Wcdma Synthesizers; General Instructions For Wcdma Rx- Or Tx-Synthesizer Troubleshooting - Nokia NHM-1 Series Troubleshooting Instructions

NHM-1
Troubleshooting instructions

WCDMA Synthesizers

General instructions for WCDMA RX- or TX-synthesizer troubleshooting

Connect test jig to computer with DAU9S cable or to FPS-8 Flash Prommer with XCS-4
modular cable.
Make sure that you have PKD-1 dongle connected to computers parallel port.
Connect DC power supply or FPS-8 to module test jig with FLC-2 cable.
Set the DC supply voltage to 3.9V and set the jumper connector on test jig to "bypass"
position.
Set the phone module to test jig and start Phoenix service sofware
Initialize connection to phone. (use FBUS driver when using DAU9S and COMBOX driver
when using FPS-8)
Select product from the menu
File -> Open product -> NHM-1
From toolbar
- Set system mode to "WCDMA"
- Set operating mode to "Local"
Page 32
Nokia Corporation.
CCS Technical Documentation
Issue 1 11/03