Wcdma2100 Receiver; General Instructions For Rx Troubleshooting - Nokia NHM-1 Series Troubleshooting Instructions

NHM-1
Troubleshooting instructions

WCDMA2100 Receiver

General instructions for Rx troubleshooting

Connect test jig to computer with DAU9S cable or to FPS-8 Flash Prommer with XCS-4
modular cable.
Make sure that you have PKD-1 dongle connected to computers parallel port.
Connect DC power supply to module test jig with FLC-2 cable.
Set the DC supply voltage to 3.9V and set the jumper connector on test jig to "bypass"
position.
Connect a signal generator to the module test jigs (MJS-46) WCDMA RF connector with
a RF-cable.
Set the phone module to test jig and start Phoenix service sofware.
Initialize connection to phone. (use FBUS driver when using DAU9S and COMBOX driver
when using FPS-8)
Choose product from the menu
File -> Open product -> NHM-1
From toolbar
- Set system mode to "WCDMA"
- Set operating mode to "Local"
Activate RF controls window from the menu
Testing -> WCDMA -> RX Control
Page 26
Nokia Corporation.
CCS Technical Documentation
Issue 1 11/03