Advertisement
5. Operational Guidelines for the Power Module
5.1 Connection to a Wall Outlet (Line Mode)
1
After you plug the power module into a live AC outlet, the power module (in "Standby" mode) will automatically charge
the battery, but it will not supply power to the output outlet until it is turned "on." The power LED (~) will not be
illuminated.
Power LED
On/Off Button
2
The battery LEDs will illuminate to indicate the charge level of the battery.
3
Let the power module charge the battery for 2 to 4 hours prior to operating. All 4 LEDs above the battery icon will
illuminate green on the Remote User Interface (RUI) when the battery is fully charged (approximately 13.5 VDC).
4
Press and hold the "On/Off" button for one second to turn "on" the power module. The alarm will beep once briefly
after one second has passed. Release the button. The power LED (~) will stay illuminated. The same steps should be
followed for powering down the power module.
5
Reference the Quick Start Guide to power and operate the Interactive Touchscreen.
5.2 Disconnection from a Wall Outlet (Battery Mode)
1
Unplug the power module from the wall outlet.
2
The battery LED will begin to flash and the alarm will begin beeping.
3
Press the Mute button on the RUI to silence the alarm, or plug the power module back into the wall outlet to charge
the battery.
Note: Unit will also supply power while in charge mode.
4
The power module will run from the charged battery.
5
LEDs on the RUI device will indicate the charge remaining in the battery.
6
When the battery is low (11.0 VDC), the alarm will start beeping. Cutoff is set at 10.5 VDC.
7
Plug the power module back into the wall outlet to charge the battery before the unit powers down.
6
Battery Charge
Level LEDs
Mute Button
Advertisement
