Arjo NDA8200 Instructions For Use Manual

Arjo NDA8200 Instructions For Use Manual

Wall mounted battery charger

Advertisement

Quick Links

INSTRUCTIONS FOR USE
Wall Mounted Battery charger
001-24257-EN rev.4 • 08/2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NDA8200 and is the answer not in the manual?

Questions and answers

Summary of Contents for Arjo NDA8200

  • Page 1 INSTRUCTIONS FOR USE Wall Mounted Battery charger 001-24257-EN rev.4 • 08/2019...
  • Page 2: Table Of Contents

    Electromagnetic Compliance..........................8 Electromagnetic Immunity..........................9 Design Policy and Copyright ® and ™ are trademarks belonging to the Arjo group of companies. © Arjo 2019. As our policy is one of continuous improvement, we reserve the right to modify designs without prior notice.
  • Page 3: General Information

    (10) years based on a usage rate of Modifications to any Arjo product may affect its two (2) complete recharge (8 hours) per day. The safety. Arjo will not be held responsible for any life span corresponds to the safe operating time incidents that...
  • Page 4: Safety Instructions

    The metal contacts must be kept This means that the battery contains lead and clean. that it must not be disposed of, but recycled. • The charger is for use only with Arjo 24V lead- acid battery type, as supplied with the lift.
  • Page 5: Installation Instructions

    Installation Instructions Installation Instructions Preparation 2) Drill holes (at markings) into the wall. Fit wall plugs into the wall if needed. • Mount the charger on a suitable wall close to an 3) Hold charger to wall, fit and electrical outlet. tighten screws, see Fig.
  • Page 6: Troubleshooting

    Storage temperature / humidity range -40 °C to 70 °C (-40 °F to 158 °F), 10 % RH to 95 % RH This Arjo product meets the requirements of the Low Voltage Directive 2014/35/EU, the regulations of the EMC Directive 2014/30/EU, ECO Design Directive 2009/123/EC and ROHS Directive 2011/65/EU.
  • Page 7: Dimensions

    Technical Specifications Dimensions CHARGER STATUS INDICATOR (LED) 45mm 1 3/4" 100mm 3 15/16" PRODUCT IDENTIFICATION LABEL 60mm 2 3/8" 46mm 1 13/16" Fig. 4...
  • Page 8: Electromagnetic Compatibility

    WARNING : Use of accessories, cables and spare parts other than those specified or provided by Arjo could result in increased electromagnetic emissions or decreased electromagnetic immunity of this equipment and result in improper operation. Electromagnetic Emissions Guidance and Manufacturer’s Declaration -...
  • Page 9: Electromagnetic Immunity

    Electromagnetic Compatibility Electromagnetic Immunity Guidance and Manufacturer’s Declaration - Electromagnetic Immunity - For all Equipment and Systems The Wall Mounted Battery Charger is intended for use in electromagnetic environment specified below. The customer or the user of the Wall Mounted Battery Charger should assure that it is used in such an environment.
  • Page 10 Electromagnetic Compatibility (continued) Guidance and Manufacturer’s Declaration - Electromagnetic Immunity - For all Equipment and Systems Electromagnetic Immunity test IEC 60601 test level Compliance level environment - guidance 3 V outside ISM bands 3 V outside ISM bands between 0.15-80 MHz between 0.15-80 MHz Conducted RF 6 V inside ISM and...
  • Page 11 JAPAN...
  • Page 12 At Arjo, we are committed to improving the everyday lives of people affected by reduced mobility and age-related health challenges. With products and solutions that ensure ergonomic patient handling, personal hygiene, disinfection, diagnostics, and the effective prevention of pressure ulcers and venous thromboembolism, we help professionals across care environments to continually raise...

Table of Contents