Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Waves CLA EchoSphere
Summary of Contents for Waves CLA EchoSphere
- Page 1 CLA EchoSphere User Guide...
- Page 2 At the heart of EchoSphere is Chris’s legendary rock sound. It was the starting point of the plugin’s design, not a tweak. Even when all the faders are set to zero, his sound is working for you. CLA EchoSphere / User Guide...
-
Page 3: Quick Start
The Plate output is sent directly to the wet/dry mixer. The large faders set the output level of each processor. Use the Wet/Dry control to set how much of the effect you want to include in the plugin output. CLA EchoSphere / User Guide... - Page 4 Filter value is shown when HP or LP is touched. Slap or Plate control panel Slap and Plate have different control panels. The Slap control panel is shown here. Modulation control Routing panel (Slap only) Wet/Dry mix Output fader CLA EchoSphere / User Guide...
-
Page 5: Delay Time
The EQ curve will not change until a new tape speed is selected. controls the amount of the tap signal that is returned to the input. The result is a repeating and EEDBACK diminishing echo. sets the signal path of the Slap output. OUTING CLA EchoSphere / User Guide... -
Page 6: Output O N /Off
When the Plate and Output switches are both on, Slap output is sent to the plugin output, as well as to the Plate. Plate output is always sent to the plugin output. It cannot be sent back to the Slap. controls Slap output level. ARGE ADER CLA EchoSphere / User Guide... -
Page 7: Plate Reverb
FREQUENCY DAMPING Reverb Time value. Higher settings yield spaces that are warmer and roomier, while lower RT Low settings tend to result in spaces that are more articulate sounding. Range: x1.5, x2.0, x3.5 CLA EchoSphere / User Guide... - Page 8 Low depth, rate: 1–100 51–75 High-medium depth, rate: 1–100 26–50 Low-medium depth, rate: 1–100 76–100 High depth, rate: 1–100 Modulating the taps produces variation in the delay times, which changes the pitch of each tap. CLA EchoSphere / User Guide...
-
Page 9: Output Section
The LED above the fader indicates output level. If the light is continuously red, reduce and output level. If the output level remains very high, check that the input level is not too high and that the Slap and Plate processors are not causing large gain increases. CLA EchoSphere / User Guide...
Need help?
Do you have a question about the CLA EchoSphere and is the answer not in the manual?
Questions and answers