Advertisement
REMOTE START INHIBIT MODE:
The PUSH BUTTON LED allows you to temporarily disable the remote
starting function of your Remote Start system.
To enter Remote Start Inhibit Mode:
1. Press and Hold the push button LED.
2. Turn the ignition ON, OFF, ON, OFF, ON, OFF.
3. The LED will begin to flash indicating it has entered Remote Start
Inhibit Mode, release the button.
To exit Remote Start Inhibit Mode:
1. Press and Hold the push button LED.
2. Turn the ignition ON, OFF, ON, OFF, ON, OFF.
3. The LED will stop flashing indicating it has exited Remote Start
Inhibit Mode, release the button.
REMOTE STARTING THE VEHICLE:
The system WILL NOT start the vehicle if any one of the following situations
exist:
1. The vehicle's hood is opened.
2. The gear shift selector is not in Park.
3. The brake pedal is depressed.
4. The safety control switch is in the Off position.
1. To start the vehicle, press and release the transmitter button 2 times
within 2 seconds. The vehicle will start and remain running for the pre-
programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending on the setting by your
installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position
(Do not try to restart the vehicle), then step on the brake pedal to disengage
the remote start. The vehicle will continue to run, but now on it's own
power.
© 2006 Code Systems, Inc
Advertisement
