Table of Contents
Advertisement
7
MAINTENANCE AND ADVICE
To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove dust, use
a soft cloth. To remove a stain, use a damp cloth.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR HEATER AS
THIS MAY DETERIORATE THE EPOXY FINISH.
Operation and maintenance tips
Your CONVECTAIR heater will become hot when in use. Caution is advised when
young children are present.
Do not insert small objects in the heater, this could cause an electrical short circuit, fire
or damage to the inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short
circuits, fire or injuries to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not
due to a manufacturing defect. This is caused by surrounding air, which may contain
smoke or dust, being heated and circulated through the heater.
Prevention : it is suggested that surfaces be frequently cleaned especially with units
installed in locations where cigarette smoke is present or in the kitchen.
Never use this heater during construction work or other activities that gene-
rate a lot of dust.
Note : The first time your CONVECTAIR heater is used, a light smoke could be re-
leased. This is normal and should disappear after about 2 to 3 minutes.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN, AND ONLY AFTER THE
HEATER HAS BEEN DISCONNECTED.
Page 15
Advertisement
Table of Contents
