Technical Parameters - TESY GCV7/4S 150 44 30 B11 TSRCP Appendix

Special features concerning the water heater with
two heat exchangers and a thermal sensor pocket are
described in this appendix.
The Base instruction manual is valid for water heaters
with two heat exchangers and a thermal sensor pocket,
except the following: Addition to paragraph VIII – "models
equipped with a heat exchanger (serpentine tube) "
Models with two heat exchangers and a thermal sensor
pocket
The installation of the unit is at the buyer's expense and
must be carried out by a professional technical person
in accordance with instructions in the manual.

Technical parameters:

Type
Surface of serpentine S1 (m²)
Surface of serpentine S2 (m²)
Volume of serpentine S1 (l)
Volume of serpentine S2 (l)
Operational pressure of
serpentine S1 (MPa)
Operational pressure of
serpentine S2 (MPa)
Maximum temperature of
heat carrier (°C)
fig. 1
English
GCV7/4S GCV7/4S GCV7/4S
10044 12044 15044
0.5 0.5 0.5
0.3 0.3 0.3
2.4 2.4 2.4
1.4 1.4 1.4
0.6 0.6 0.6
0.6 0.6 0.6
80 80 80
440
These models allow for connection to two external heat sources
– a solar panel and local or central water heating supply.
Serpentine markings:
•
S1 and an arrow pointing at the serpentine lead-in –
inlet of serpentine S1
•
S1 and an arrow pointing outwards from the serpentine
lead-in – outlet of serpentine S1
•
S2 and an arrow pointing at the serpentine lead – inlet
of serpentine S2
•
S2 and an arrow pointing outwards from the serpentine
lead-in – outlet of serpentine S2
There is a connexion with internal thread of ½" welded
to the water tank for the purposes of installing thermal
probe – marked with „TS". The appliance is fitted with brass
pocket for a thermal probe which should be screwed into
the aforesaid connexion.
See fig. 1:
Dimensions, mm [±5]
Type GCV7/4S
10044
A 927
Appendix to instruction for use and maintenance
GCV7/4S GCV7/4S
12044 15044
1137 1302
440
3
EN