Flintec FRD-57 Technical Manual

Flintec FRD-57 Technical Manual

Remote display led

Advertisement

Quick Links

FRD-57
Remote Display LED
Technical Manual
Flintec GmbH
Bemannsbruch 9
74909 Meckesheim
GERMANY
www.flintec.com

Advertisement

Table of Contents
loading

Summary of Contents for Flintec FRD-57

  • Page 1 FRD-57 Remote Display LED Technical Manual Flintec GmbH Bemannsbruch 9 74909 Meckesheim GERMANY www.flintec.com...
  • Page 2: Table Of Contents

    FLINTEC reserves the right to revise this manual and alter its content without notification at any time. Neither FLINTEC nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or failure to strictly comply with FLINTEC operating and maintenance instructions.
  • Page 3: Safety Instructions

    FOR FUTURE REFERENCE. DO NOT ALLOW UNTRAINED PERSONNEL TO OPERATE, CLEAN, INSPECT, MAINTAIN, SERVICE, OR TAMPER WITH THIS EQUIPMENT. ALWAYS DISCONNECT THIS EQUIPMENT FROM THE POWER SOURCE BEFORE CLEANING OR PERFORMING MAINTENANCE. CALL FLINTEC ENGINEERING FOR PARTS, INFORMATION, AND SERVICE. WARNING! ONLY PERMIT QUALIFIED PERSONNEL TO SERVICE THIS EQUIPMENT.
  • Page 4: Introduction

    2 Introduction The Remote Display Type FRD-57 in the wall housing can be used in many weighing applications, where good readability is required. The following Flintec devices are supported: FT-1x, FT-10 und FT-11x FT-0x DAD72.1, DAD141.1 The remote display is characterized by low power consumption.
  • Page 5: Installation

    FT-0x / LDU, DAD14x.x, DAS72.1 FT-0x Data N,8,1 N,8,1 E,7,1 Dip SW (on) 3, 4 Operation mode (Jumper JP1, JP 2) RS-232 20mA cur.Loop RS-485 Figure 2 FRD-57 Remote Display LED, Technical Manual Rev.2.1, October 2018 Page 4 of 8...
  • Page 6: Connection Examples

    6 Connection Examples 6.1 FRD-57 and FT-1x / FT-10 / FT-11x • Operation port: RS232 • DIP Switch S1 (ON): 2, 3, 4 (=9600, 8N1) • Jumper: • PIN connection: FT-1x, FT-10, Signal FRD-57 FT-11x Pin 2 Pin 7 SGND •...
  • Page 7: Dimensions

    7 Dimensions FRD-57 Remote Display LED, Technical Manual Rev.2.1, October 2018 Page 6 of 8...
  • Page 8 Bemannsbruch 9 D-74909 Meckesheim Deutschland / Germany E-Mail: germany@flintec.com http:// www.flintec.com FRD-57 Remote Display LED, Technical Manual Rev.2.1, October 2018 Page 7 of 8...

Table of Contents