Table of Contents
Advertisement
Quick Links
... the right weigh
45 mm LCD Numerical Display
FRD – 45 BL
MANUAL
Release 10.11.2006
This manual was created with special care on the technical content and the correct
verbalisation. However, as a matter of principle Flintec GmbH will not take
responsibility for any damage caused by missing or wrong informations
FRD-45 BL Manual
page 1 of 8
Advertisement
Table of Contents
Related Manuals for Flintec FRD-45 BL
Summary of Contents for Flintec FRD-45 BL
- Page 1 Release 10.11.2006 This manual was created with special care on the technical content and the correct verbalisation. However, as a matter of principle Flintec GmbH will not take responsibility for any damage caused by missing or wrong informations FRD-45 BL Manual...
-
Page 2: Table Of Contents
General Safety Guidelines The following general safety guidelines apply to all Flintec - products: All applicable safety and accident prevention recommendations must be observed (VDE 0100 and VDE 0113). -
Page 3: Characteristics
The unit contains negligible amounts of combustible materials, and will not support a fire. No toxic or hazardous material is used. Fulfills RoHS directive (lead free) from november 2005 (= from serial No 1000 on) FRD-45 BL Manual page 3 of 8... -
Page 4: Electronics
Pin 6 TTY+ Input positive 20 mA I/O connects to RS-485/422 Pin 7 sender/receiver I/O connects to RS-485/422 Pin 8 sender/receiver Pin 9 +V DC Connects to External Power Programming Cable PIN Assignement FRD-45 BL Manual page 4 of 8... -
Page 5: Operation Notes
(-), decimal point (represented by '.' or','), leading blanks or zeros. Addressing Control <SOH> AA <STX> will select display AA (00 to 99). 00 will broadcast to all connected displays. Addressing is used relatively seldom FRD-45 BL Manual page 5 of 8... -
Page 6: Programming Operational Parameters
Decimals (place fixed dp) EXAMPLE To set the baudrate to 4800, issue the command: cmd[ s=status] >C=4800[Enter] The PC/terminal will reply with an "ok" if accepted, else "* err". Use the „S"-command frequently. FRD-45 BL Manual page 6 of 8... - Page 7 EC – Declaration of Conformity Flintec GmbH Bemannsbruch 9 D-74909 Meckesheim The following named product: FRD-45 BL Display is conform to the following european directives and standards: EN55011, EN50082 (Part 1 and 2) and CENELEC EN 60742 Meckesheim, 1.3.2001 Gerhard K. Adam Geschäftsführer...
-
Page 8: Service And Contact Information
... the right weigh 4. SERVICE AND CONTACT INFORMATION Flintec GmbH Bemannsbruch 9 74909 Meckesheim Germany Tel.:+49 6226 9240 0 Fax :+49 6226 9240 99 http://www.flintec.com FRD-45 BL Manual page 8 of 8...