Toro ProPass 200 Installation Instructions Manual page 7

1. Hydraulic pump
39. On the SH version, model 44701, remove the
fasteners securing the cover to the front of the
ProPass and set the cover aside
1. Cover
40. Identify the pressure and return connections on
the ProPass base model. Refer to
for the SH versions and
versions.
1. Pressure
Figure 12
2. Hydraulic hose #4
(Figure
Figure 13
Figure 14
Figure 15 for the EH
Figure 14
2. Return
g013908
1. Return
41. If pressure and return hoses were previously
installed at the locations shown in
13).
Figure
Note:
hot, sharp or moving parts. Try to attain as much
clearance from the muffler as possible.
42. Connect the hydraulic hoses to the hydraulic
control panel. Refer to
on the SH versions and
17 on the EH versions.
g013845
1. Hose routing
g014215
7
Figure 15
2. Pressure
15, remove them.
Make sure the hoses do not contact any
Figure 14
Figure 15
Figure 16
g259001
Figure 14 and
and Figure 16
and Figure
g013867