Instructions And Purpose; Mounting - Carbest 62055 Instruction Manual

Congratulations to the purchase of your Carbest fresh water pump. In this manual you will find all
information to get your water pump in use quickly.
With regular maintenance this fresh water pump will serve you for many years.

INSTRUCTIONS AND PURPOSE:

The appropriate installation and operation are the requirements for a long durability of the pump
as well as for the validity of the existing warranty.
Therefore please read the manual carefully prior the installation and take notice of the following
operation- and maintenance instructions.
• The Carbest fresh water pumps 62055 and 62056 have a CE-certification.
• Pump capacity art. 62055: 1,4 bar, 7 liter / min.
• Pump capacity art. 62056: 2,8 bar, 10 liter / min.
• For mounting at the interior.
• Not applicable for mounting at wet room or underwater area.
• Not applicable for installation in a reverse osmosis system.
• The pump system is not acid-resistant.
• Not applicable for permanent operation, respective duty cycle max.20min.
• Integrated pressure valve for a consistently water pressure, low-noise operation and
higher durability.
• By non-use of the water system switch off the pump!

MOUNTING:

• Mounting on a firm subsurface enabling a vibration-free, quiet running.
• Pay attention for an easy access for operating and maintaining (i.e. change of
the filter).
• The pump capacity is interpreted for a max. line length to the fresh water tank of
2,00m.
• Consider that the installation space has enough ventilation for the pump: Installation
space with a min. of a 20 l-volume (protection against excessive heat).
• Positioning of the pump: horizontally (i.e. at a base plate) or vertically (i.e.at a side
wall), then pump head downwards.
• Use appropriate hose material for feed line and exit (i.e. from the Reimo product
range), length each before/after the pump min. 60cm.
• Pay attention to the conformity with the drinking water ordinance at pipes for drinking
water systems (more information under www.reimo.com).
• Do not use rigid metal- or plastic pipes at the pump's immediate inflow and exit
as well as at the filter. (Danger of vibration transmission, leakages, blistering etc.).
• Install the coarse filter in front of the pump entrance, i.e. Reimo art. no. 65302. (Pro-
tection against particles).
• For an optimal operation use hose lines with an inner diameter of 12mm / ½ inch or
bigger.
• Avoid constrictions in the inner diameter (i.e. elbows, fittings, stop valves etc.).
• Control screwed connections regularly for its tightness and if necessary retightening
(danger of relaxation by vehicle vibrations).
9