Setup
Installing the Handle
Secure each side of the handle to the plate compactor frame
using a bolt, flat washer, spacer, bearing, lock washer, and nut
(Figure 3 or Figure 4).
Model no. 2200
1. Nut
2. Bearing
3. Handle
Figure 3
4. Spacer
5. Flat washer
6. Bolt
1
2
g019693
Model no. 3000/4000
1. Nut
2. Lock washer
3. Bearing
4. Handle
Checking the Engine Oil Level
The machine comes from the factory with oil in the engine
crankcase; however, it may be necessary to add oil. Refer to
Servicing the Engine Oil (page 13). Add only enough oil to
raise the level to the Full mark on the dipstick.
Checking the Eccentric Oil
Level
The machine comes from the factory with eccentric oil in
the eccentric housing; however, it may be necessary to add
oil. Refer to Servicing the Eccentric Oil (page 13). Add only
enough oil so that the oil level is flush with the oil plug on the
side of the eccentric housing.
6
3
4
5
6
Figure 4
5. Spacer
6. Flat washer
7. Bolt
7