Download Print this page

Eliminating The Arm / Disarm Chirps - Audiovox Prestige APS-25KB Owner's Manual

2 button remote security system with shock sensor
Hide thumbs Also See for Prestige APS-25KB:

Advertisement

ELIMINATING THE ARM / DISARM CHIRPS:

The normal arming and disarming confirmation "chirps" can easily be turned on and off using
the valet toggle switch. To do this...
1. The valet switch must be in "off" position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch to the
on-off-on-off-on-then off.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps to indicate
that the chirps have been turned off.
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp to indicate
that the chirps have been turned on.
5. Whenever power to the system is disconnected (for repair or service of the vehicle), the
chirps will be active when power is re-connected. To turn the chirps off, simply execute
1-3 above.
Note: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp intrusion indicator will
always operate. This feature will always warn you if there is a defective sensor during
the arming sequence or if the vehicle had been tampered with in your absence, even
if the normal arming and disarming chirps have been turn off.
REMOTE PANIC OPERATION (CHANNEL 1):
The arming button on your keychain transmitter also functions as a "panic" switch for instant
activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more.
The alarm will immediately sound.
2. To stop the alarm, press and release the arming button on the keychain transmitter.
If the button is not pressed, the alarm will automatically stop after 30 seconds.
WARNING! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
TRUNK RELEASE (CHANNEL 2):
This security system has an additional feature that can be wired to a number of different
optional accessories. Some of the more common uses for this "channel" are:
l Remote Trunk Release - available for any vehicle with factory installed electronic
push-button trunk release.
l Remote Car Starter - available for most automatic transmission, fuel injected vehicles.
l Remote Window Roll Up - available for most vehicles equipped with power windows.
To activate the optional accessory:
1. Press and hold the smaller button on the keychain transmitter for approximately
3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".
Page 4

Advertisement

loading