Your APS-20 Vehicle Alarm System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular system. Consult your installing dealer for options that may have been installed and are not listed.
PROTECTION WHILE THE SYSTEM IS ARMED: (continued) cause the shock detector to trigger the alarm when armed. If the optional 2-stage shock sensor is installed, any lesser impact will cause the pre-detect stage of the shock sensor to emit a series of short warning tones from the siren when armed. If the optional stater interupt is installed the vehicle starter circuit is disabled, even with the ignition key the vehicle will not start.
VALET/PROGRAM/MANUAL OVERRIDE SWITCH (continued) The dash mounted LED will turn on solid indicating that the valet mode has successfully been entered. To return to the normal, (alarm mode), operation, move the valet switch to the "off" position any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to oper- ate the alarm system, the valet switch can be used to disarm the alarm.
REMOTE PANIC OPERATION The left button of your keychain transmitter also serves as a panic switch and will cause the siren to sound on demand. To use the panic feature, you must be within the system's maximum operating range. In an emergency situation, to use the panic feature, press and hold the left button of your keychain transmitter for 3 seconds.