Download Print this page

Audiovox APS-20A Owner's Manual

2 button vehicle alarm system with channel 2 auxiliary output

Advertisement

Quick Links

2 Button Vehicle Alarm System
With Channel 2 Auxiliary Output
FEATURES:
2 Two Button, 3 Channel RF Transmitters
Two Channel Code Learning Receiver
Remote Panic In All Modes
Built-In Parking Light Output
LED Status Indicator
Multi-Tone Siren
True Last Door Arming
Channel 2 Auxiliary Output
OPTIONS:
Remote Trunk Release
Remote Power Window Control
Remote Garage Door Interface
Remote Engine Starter
Single or Dual Stage Shock Sensor
Stater Interrupt
Keyless Entry
Ignition Control Door-locks
Model APS-20
Owner's Manual
Page 1

Advertisement

loading

Summary of Contents for Audiovox APS-20A

  • Page 1 2 Button Vehicle Alarm System With Channel 2 Auxiliary Output FEATURES: 2 Two Button, 3 Channel RF Transmitters Two Channel Code Learning Receiver Remote Panic In All Modes Built-In Parking Light Output LED Status Indicator Multi-Tone Siren True Last Door Arming Channel 2 Auxiliary Output OPTIONS: Remote Trunk Release...
  • Page 2: Arming The System - Active

    Your APS-20 Vehicle Alarm System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular system. Consult your installing dealer for options that may have been installed and are not listed.
  • Page 3: Disarming The System

    PROTECTION WHILE THE SYSTEM IS ARMED: (continued) cause the shock detector to trigger the alarm when armed. If the optional 2-stage shock sensor is installed, any lesser impact will cause the pre-detect stage of the shock sensor to emit a series of short warning tones from the siren when armed. If the optional stater interupt is installed the vehicle starter circuit is disabled, even with the ignition key the vehicle will not start.
  • Page 4: Eliminating The Arm/Disarm Chirps

    VALET/PROGRAM/MANUAL OVERRIDE SWITCH (continued) The dash mounted LED will turn on solid indicating that the valet mode has successfully been entered. To return to the normal, (alarm mode), operation, move the valet switch to the "off" position any time the ignition switch is in the on position. Note: In the event that you lose your keychain transmitter or the transmitter fails to oper- ate the alarm system, the valet switch can be used to disarm the alarm.
  • Page 5: Remote Panic Operation

    REMOTE PANIC OPERATION The left button of your keychain transmitter also serves as a panic switch and will cause the siren to sound on demand. To use the panic feature, you must be within the system's maximum operating range. In an emergency situation, to use the panic feature, press and hold the left button of your keychain transmitter for 3 seconds.
  • Page 6 SIREN CHIRP INDICATION: 1 CHIRP 2 CHIRPS 3 CHIRPS 4 CHIRPS CONTINUOUS ALARM PARKING LAMP INDICATIONS: 1 FLASH 2 FLASHES 3 FLASHES CONTINUOUS FLASH © 1999 Audiovox Corp. ú÷òü÷üþò þüü ø÷öüûú úýüüþú ûüü ööò öööòý ööò öööòý ööò öööòý öööòý...

This manual is also suitable for:

Aps-20b1285492Prestige aps-20