Immergas System Manager Kit Instructions And Warnings page 45

The zone remote control manages the heating/cooling
of the associated zone.
The functions valid for the secondary remote zone con-
trol are enabled with:
- Buttons to the side of the display (Ref. 2 - 3 Fig. 7-2)
allow to select the available functions.
- main switch (Ref. 1 Fig. 7-2) by turning it one can
select the values of the parameters. The parameter be-
ing edited flashes, to store the selected value press the
main selector.
Programming current time and day. Press and hold
the "time slot " button until the "
tion appears.
2
Select the function and adjust it according to the current
time and day.
" func-
Clock
3
1
Fig. 7-2
Fig. 7-3
Ignition. Press and hold the "on / off
remote control goes into stand-by and displays the
operating modes, the room temperature and the time.
Select operating mode. By pressing the "Mode
button one can select the operating mode of the system
in cyclic mode between:
- "Summer with cooling "
cooling (performed by the heat pump) and domestic
hot water production mode.
- "Winter " ", system operating in room heating and
domestic hot water production mode.
- "Domestic hot water
hot water production mode only.
Time slots adjustment. The "Time band" parameter
enables to adjust the room temperatures in time slots,
it is possible to adjust up to a maximum of 6 time slots
and the programming can be set day by day for the whole
week, for 5 days (Mon-Fri) and 2 days (Sat-Sun).
Press and hold the "time band
" " function appears, turn the main selector
Clock
until the "
Time band
45
" button; the
Fig. 7-4
", system operating in room
", system operating in domestic
" button until the
" parameter appears
"