Dafra DNP3212-2 Instructions Manual

PLEASE SPEND 2 MINUTES READING
THESE INSTRUCTIONS BEFORE USING
YOUR NEW DNP3212-2 RIVNUT TOOL.
TRUST US, IT WILL SAVE YOU TIME AND
INCONVENIENCE IN THE LONG RUN.
READ THIS MANUAL CAREFULLY BEFORE USING THE TOOL!
It is IMPORTANT
against injuries.
- This tool should be used ONLY to set blind rivets within the TOOL'S CAPACITY. It MUST
NOT be used for other purposes, such as hammer, etc.
- This tool should be always operated with compressed air supply within the air pressure range
0.5Mpa ~ 0.7Mpa.
- Always DISCONNECT the air supply from the tool before changing tool parts, such as
mandrel, etc.
- DO NOT use the tool in the environment described as below:
 fuel and combustion air.
 temperature rapidly rising.
 humidity, rain, water, storm and thunder, lightning.
- When the tool is suspended by the operation hook during use, be sure the tool will not fall.
- When using the tool, always carry protective goggles, protective gloves, safety helmet, and
other necessary protections. It is highly recommended for safety reasons.
- Only use genuine spare parts for maintenance and repairs.
- All repair work must be carried out by skilled personnel, when in doubt, always return the tool
to the distributor.
to follow the safety instructions for adequate protection