Mazda 3 2019 Owner's Manual page 459

CAUTION
When removing the lens or lamp unit using
a flathead screwdriver, make sure that the
flathead screwdriver does not contact the
interior terminal. If the flathead screwdriver
contacts the terminal, a short circuit may
occur.
NOTE
When replacing a bulb, contact an

Authorized Mazda Dealer if necessary.
Use the protective cover and carton for

the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.
For details regarding the installation

positions of the interior lights, refer to
the following:
Vanity mirror lights

Refer to Vanity Mirrors on page 5-33.
Overhead Lights/front map lights,

overhead light (rear), trunk light, and
luggage compartment light
Refer to Interior Lights on page 5-34.
▼ Replacing Exterior Light Bulbs
The exterior lights have either LEDs or
normal bulbs.
Only the bulb for a parking lights/front
side-marker lights (type B) can be
replaced.
LED type
Headlights

Daytime running lights

Parking lights (Type A)

Front turn signal lights

Front side-marker lights (Type A)

Side turn signal lights

*
Owner Maintenance
High-mount brake light

Rear turn signal lights

Rear side-marker lights

Brake lights

Taillights

Reverse lights

License plate lights

The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorized
Mazda Dealer when the replacement is
necessary.
Bulb type
Parking lights/Front side-marker lights
(Type B)
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. If you are changing the left bulb, start
the engine, turn the steering wheel all
the way to the right, and turn off
engine. If you are changing the right
bulb, turn the steering wheel to the left.
3. Pull the center of each plastic retainer
and remove the retainers.
1. Removal
2. Installation
Maintenance and Care
6-35
*Some models.