Replacing The Filter - Breville AirRounder Connect Instruction Book

REPLACING THE FILTER

Your AirRounder™ Connect purifier fan heater
filter should be replaced in the time frames
indicated below. The filter life is approximately
3 months if used 24 hours daily, or 6 months if
used 12 hours daily.
• The filter life may vary to this timing
depending on environmental conditions.
• Remove all packaging from the replacement
filter and place the filter into the unit as
described below.
1. Remove the rear housing cover (Fig 5).
Fig. 5
2. Remove the used filter using the pull tabs
on the filter (Fig 6).
Fig. 6
3. Remove all packaging from the replacement
filter then place into the purifier fan heater
with pull tabs facing the opening (Fig 7).
Fig. 7
4. Ensure the filter is correctly fitted.
5. Replace the rear housing cover (Fig 8).
Fig. 8
Press and hold the
panel for 10 seconds to reset the filter. REPLACE
FILTER icon will no longer illuminate on the
LED display panel.
NOTE
There is no top or bottom on the filter. The
filter can be placed into the unit either way.
NOTE
If the filter is not in place or not fitted correctly,
the purifier fan heater will not operate.
button on the control
21