nologo COPY-CONTROL Manual

GB_COPY-CONTROL_160909_VX8503
When you give power supply to the COPY-CONTROL (12VAC/DC), it turns on automatically and you can see a number on
the display for a while, this indicate the number of the software. (For example after the FUNCTION NO.1).
GB
COPY-CONTROL
P1
FUNCTION BUTTON
This button can activate one of the three functions, besides,
in the FUNCTION 3, it confirm right memorisation of the
code.
P2
ENTER BUTTON/ ESC/ MEMORISATION
This button can confirm or not confirm one of the functions,
previously selected, with the button P1, besides, in the
FUNCTION 3, it needs to memorize the code inside the
machine and it can be choosen to transmit the memorized
code.
1
FUNCTION
Select the FUNCTION no.1 with the button and keep pressed till you see in the display the number 1.
P1 Press the button P2 to confirm the operation and go in the program.
The right position of the remote control is indicated in the picture
1 area 1, we recommend to find the position of the antenna of
the remote control, normally it is in the lower part of the remote
control but it is not always the technical structure and the design of
the remote control , and vice versa, so we can find the antenna in
another position. When you press the button of the remote control
the two RED L.E.D. of the COPY-CONTROL start flashing fast,
indicating the begining of the reading.
In particular the reading of the frequency is precise from 250 Mhz
to 869 Mhz
When you are in this function you can read an adjust the frequencies without going out or enter in the same functions.
To go out press the button esc P2.
COPY-CONTROL
Pressing repeatedly the P1 you will see numbers which
indicate the three functions available:
• FUNCTION 1:
• FUNCTION 2:
• FUNCTION 3:
• FUNCTION 3bis:
Functions
1 - 2 - 3
frequency reader in Mhz
frequency adjuster of the
oscillator (maximum value
is 1024)
memorisation of the remote
control's code and check of the
right memorization of
the original remote control
indicating the right percentage
of the good learning.
Transmission of the code
between the
COPY-CONTROL and
the copied remote control.
(between 250 and 869 Mhz).