Wiring - Audiovox VM8012 Installation And Operation Manual

VM8012

WIRING

NOTE: The amplifier in this radio is
only designed for use with four
speakers. Never combine (bridge)
outputs for use with two speakers.
Never ground negative speaker
leads to chassis ground. Failure to
wire exactly as shown may cause
electrical damage to the radio.
NOTE: Only connect speakers with
a nominal impedance of 4 ohms.
Speakers with a load impedance
less than 4 ohms could damage
the unit.
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Yellow
FRONT SP
White/Black White Gray/Black Gray
Stripe Stripe
Left Speaker Right Speaker
(Front) (Front)
Subwoofer Out
Parking SW (Active Low Level Input)
Aux-In (Black)
Video In
Video Out
USB Slot
Fuse (15A)
Rear Line out
R (Red)
Gray
L (White)
Front r Line out
R (Red)
Black L (White)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Red
REAR SP
Green/Black Green Purple/Black Purple
Stripe Stripe
Right Speaker
Left Speaker
(Rear) (Rear)
3
R (Red)
L (White)
(Yellow)
(Yellow)
A/V Media
Adapter Cable
IMPORTANT!
The pink parking wire MUST
be connected to the switched
side of the parking break
circuit (the part that becomes
grounded when the brake is
applied).