Everhard Industries NUGLEAM 35L Installation & Care Instructions

Everhard Industries NUGLEAM 35L Installation & Care Instructions

Soft close laundry unit

Advertisement

Quick Links

NUGLEAM 35L & 45L SOFT CLOSE LAUNDRY UNIT
35L | EI code: 71S02
45L | EI code: 71S01

INSTALLING YOUR LAUNDRY UNIT

1.
Carefully lift product out of the carton.
2.
The laundry unit must be installed at the location of the drain (refer to Connecting the Laundry Sink to the Drain
section). Check the dimensions of the area where the laundry unit will be installed to ensure it will fit within the
allocated space.
3.
Ensure the back wall of the area where the laundry unit will be installed is straight and level.
4.
Carefully remove the laundry sink from the unit using protective gloves and set aside.
5.
Install the basket waste onto the sink. The basket waste is a two part waste, therefore the screw within the middle of
the waste needs to be removed before installing the waste onto the sink. Insert the top part of the waste including
the thin black rubber seal into the waste hole of the sink. From underneath install the bottom part of the basket
waste including the thick black rubber onto the waste hole. Screw the stainless steel threaded screw through the
top part of the basket waste into the bottom part of the basket waste and tighten using a screwdriver.
6.
Ensure the laundry unit is installed level by using a spirit level across the top of the unit. If the floor is not level we
recommend using the optional adjustable feet which can be purchased separately.
everhard.com.au | 131 926
Interior
Drainage
Products
Solutions
INSTALLATION & CARE INSTRUCTIONS
Environmental
Civil &
Commercial
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NUGLEAM 35L and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Everhard Industries NUGLEAM 35L

  • Page 1 NUGLEAM 35L & 45L SOFT CLOSE LAUNDRY UNIT INSTALLATION & CARE INSTRUCTIONS 35L | EI code: 71S02 45L | EI code: 71S01 INSTALLING YOUR LAUNDRY UNIT Carefully lift product out of the carton. The laundry unit must be installed at the location of the drain (refer to Connecting the Laundry Sink to the Drain section).
  • Page 2 EVERHARD INDUSTRIES ABN: 41 009 690 859 everhard.com.au | 131 926 Head Office: 454 Newman Rd, Geebung, QLD, 4034 Using two screws or wall anchors, fasten the laundry unit to the wall by drilling two holes into the top bracket approx 300mm centres and insert fastening screws (M6) or wall anchors to secure the unit to the finished wall.
  • Page 3 EVERHARD INDUSTRIES ABN: 41 009 690 859 everhard.com.au | 131 926 Head Office: 454 Newman Rd, Geebung, QLD, 4034 REVERSING THE LAUNDRY UNIT DOOR The Nugleam Soft Close Door can be reversed from right to left hinged if required. To reverse the door, remove the two white hinge caps located on the door by using a screwdriver.
  • Page 4 EVERHARD INDUSTRIES ABN: 41 009 690 859 everhard.com.au | 131 926 Head Office: 454 Newman Rd, Geebung, QLD, 4034 POSITIONING OF HOT AND COLD WATER PLUMBING CONNECTIONS Ideal location Ideal location for hot and for hot and cold plumbing cold plumbing...

This manual is also suitable for:

Nugleam 45l71s0171s02

Table of Contents