Table of Contents
Advertisement
Quick Links
P. O. B
281 S
G
OX
AN
Dimensions: 5-3/4" High,
FEATURES
2 Ranges
Internal Batteries
External Power Input Capability
Continuous/Interrupted Operation
Insulator Test
Fully adjustable current output 0 mA to 10 amps
BATTERIES ARE INCLUDED - (1) 12 volt lead/acid and (1) 9 volt
NOT FOR USE IN AN EXPLOSIVE ATMOSPHERE
Web: www.tinker-rasor.com
CORROSION MITIGATION INSTRUMENTATION
, C
91778
T
ABRIEL
A
P
I
RODUCT
NSTRUCTIONS
CS-10
PORTABLE - 10 AMP CURRENT SOURCE
for Cathodic Protection Testing
12-1/4" Wide,
Warranty: 90 Days
– 1 –
: (626) 287-5259
F
EL
10" Long
Weight: 8.0 pounds
TESTS
Current Requirement
Short Identification
Insulator Location
Short Location
Casing Tests
E-mail: Info@tinker-rasor.com
: (626) 287-0132
AX
Advertisement
Table of Contents
Related Manuals for Tinker & Rasor CS-10
Summary of Contents for Tinker & Rasor CS-10
- Page 1 CORROSION MITIGATION INSTRUMENTATION P. O. B 281 S 91778 : (626) 287-5259 : (626) 287-0132 ABRIEL RODUCT NSTRUCTIONS CS-10 PORTABLE - 10 AMP CURRENT SOURCE for Cathodic Protection Testing Dimensions: 5-3/4” High, 12-1/4” Wide, 10” Long Weight: 8.0 pounds FEATURES TESTS...
- Page 2 Out condition, the Limiting Indicator L.E.D. will start flashing. The Low Voltage Lock-Out can only be reset when the CS-10 is turned off for 15 seconds and turned back on. At this point in time, it is recommended that the batteries be recharged immediately or use an external power source.
- Page 3 2. 1 off - 4 on, 3. 2 off - 8 on, 4. 6 off - 14 on, (in seconds). BATTERIES The CS-10 comes with a 12 volt lead/acid battery and can be operated with a 12 volt external power source (i.e., truck battery). The battery that controls the LCD is a standard 9 volt transistor battery.
- Page 4 How large is it? Has the protection level changed dramatically in a short time? When the CS-10 is connected to the structure, as in the current requirement test, and current is applied in the continuous mode, does it take more current than would be anticipated to increase the protective level? If so, there is a high probability that there is a short (additional load connected) to the protected system.
- Page 5 Tinker & Rasor strongly suggest all repairs be performed by Tinker & Rasor. All warranty work must be performed by Tinker & Rasor. Many of the CS-10 components may not be readily available to outside repair agencies. All repairs are turned around in 24 hours.
Need help?
Do you have a question about the CS-10 and is the answer not in the manual?
Questions and answers