Advertisement
Connecting an optosensor by Witt-Sensoric to Radio 8113 IP
Module that provides the function of
an optosensor or/and other safety sensors
connection (parallel connection)
To contact 8
Antenna
Motor
Contacts of the module:
14 - common contact (white);
15 - signal contact (green);
16 - +5V contact (brown).
Common
Signal
Programming
button
Two-button
switch
Electronic block of optosensors
Optosensors
by Witt-Sensoric
To connect an optosensor by Witt-Sensoric to Radio 8113 IP,
please, follow the steps below:
switch power off the Radio 8113 IP receiver;
remove module 1 from the PCB of the receiver;
connect the white common cable of the sensor to contact 14;
conntect the signal green cable of the sensor to contact 15;
connect the power supply brown cable of the sensor to contact
16;
place the module back on the PCB;
bridge contacts 2 and 3 of the module to have a stop reaction for
the sensor's command or contacts 3 and 4 to have a stop and up
reaction for the sensor's command;
connect the module's cable to contact 8 of the receiver;
switch on the Radio 8113 IP receiver.
Note: when module 1 and sensors by Witt-Sensoric are used,
contacts 8 and 11 of the Radio 8113 IP receiver are not active. To
stop the motor of the roller shutter, it is necessary to touch the
button of the opposite direction on the connected switch.
Advertisement
