Advertisement
Luralite
GLUEBOARD REPLACEMENT
BEFORE REPLACING THE GLUEBOARD, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The glueboard should be replaced every month with a genuine glupac™ glueboard. Use of
non-approved glueboards may invalidate your guarantee.
To replace the glueboard...
1. Remove the used glupac™ glueboard by simply sliding it out from the top of the unit
and either retain for catch evaluation or dispose of it hygienically.
2. Remove the protective release paper from the new glupac™ glueboard.
3. Slowly slide the new glupac™ glueboard into position with the adhesive side facing
the tube(s).
Always ensure the selected genuine glupac™ glueboards are compatible with your unit,
available from your PCO or P+L Systems Ltd.
TUBE REPLACEMENT
BEFORE REPLACING THE TUBE(S), ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
To ensure the efficiency of Luralite in catching flying insects, the UV tube(s) should be replaced
annually. After twelve months the phosphor coating that emits the correct wavelength of UV
light has burnt away and the UV output is diminished substantially.
To replace the UV tube(s)...
Luralite Cento
Luralite Professional
STARTER REPLACEMENT
BEFORE REPLACING THE STARTER(S), ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The starter(s) provide(s) an extra spark to initially light the UV tube(s). Starter(s) wear out and
should be replaced at the same intervals as the UV tube(s).
To replace the starter(s)...
1. Remove the glueboard from the units described above.
2. Rotate the starter anti-clockwise.
3. Pull the starter free from the unit.
SPECIFICATION / REPLACEMENT PARTS
Unit
Luralite
Voltage
230V ~ 50Hz
Dimensions(mm) 465 x 170 x 200
Coverage
25 Sq. Metres
Weight
1.5 Kg
Light Output
18W
Tubes
1 x I815
Starter
1 x I154
Glueboards (x6)
INL118
Wall Fixing points 190mm
R1 01/08
P+L Systems Ltd
Ten St James Business Park
Grimbald Crag Court
Knaresborough
HG5 8QB
UK
1. Pull the tube gently from the tube holder until it un-clips.
2. Gently rotate the tube until it becomes free from the tube support.
3. Reverse the process with the replacement tube.
1. Rotate the tube through 90 degrees.
2. Gently pull the tube away from the unit.
3. Reverse the process with the replacement tube.
Cento
Unit
Voltage
Dimensions(mm) 730 x 210 x 200
Coverage
Weight
Light Output
Tubes
Starter
Glueboards (x6)
Wall Fixing Points 380mm
T +44 (0)800 988 5359
F +44 (0)1423 863 497
W www.pandlsystems.com
E info@pandlsystems.com
Luralite
Professional
230V ~ 50Hz
50 Sq. Metres
2.5 Kg
30W
2 x I616
2 x I154
INL121
Decorative Glueboard Insect Control
Information provided on these instructions is modified and
updated from time to time.
This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
P+L Systems Ltd
2008
C
Advertisement
