Advertisement
6. Your 236I - WRX Receiver will now be able to communicate with your 236i Panel. Test all functions via remote i.e.
arm/disarm, panic etc, and then test all wireless sensors that have been programmed into your 236i - WRX Receiver.
4
2
1
MODE
Channel 1
TO ENTER PROGRAMMING MODE:
1. Disconnect power from the receiver.
2. Press & keep holding down the green (left) button.
3. While still holding down the green button, reconnect power to the receiver.
4. Keep holding the green button down until the LED lights stop scrolling.
5. You are now in Programming Mode.
TO EXIT PROGRAMMING MODE:
1. Press & keep holding down the green (left) button, until the LED lights begin to scroll again (approx. 5 seconds).
SELECTING THE CHANNEL YOU WISH TO PROGRAM:
Each of the four channel LED lights represent a channel number (8, 4, 2 or 1). Each press of the BLUE button will increase
by one the channel number. To select the channel you want, add the values of the lights that are on. That is, if you want
channel 5 then you should press the blue button until channel lights 4 and 1 will be on (4+1=5). When selecting a channel
disregard the three (3) feature mode LED lights. The Channel Select LED's can indicate up to Channel 15 (8+4+2+1). The
channel value will loop back to channel 1 after it reaches channel 15 (the highest channel).
8
4
2
1
CHANNEL 1
8
4
2
1
8
4
2
1
CHANNEL SELECT
2
3
8
4
2
1
CHANNEL 2 (Zone 1)
8
4
2
1
STICKER SHOWING
4 DIGIT PIN NUMBER
4
5
6
8
4
2
1
CHANNEL 3 (Zone 2)
8
4
2
1
7
8
!
IMPORTANT
When programming,
make sure that no
detectors are
transmitting, as they
will interfere with your
programming
procedure.
8
4
2
CHANNEL 4 (Zone 3)
8
4
2
1
1
3
Advertisement
