C&K systems 236i-WRX Manual page 2

Narrowband wireless receiver with 2 x code hopping remote controls

During the normal operation of the unit and when it is first powered, the LED lights located near the outputs of the

WRX

will light up sequentially (scrolling). If the unit has a fault, all 4 channel select LED's will flash. If a problem occurs

contact your C & K dealer.

YOU MUST ENTER YOUR 236I - WRX USER PIN, SHOWN ON THE STICKER NEAR THE CONNECTOR

BLOCK ON THE RECEIVER. FOLLOW THE PROCEDURE DETAILED BELOW

1. Enter your Panel Master Pin, then push the * key, enter the digit "0", then push the # key.

The Power, Service, & Arm lights will slowly flash on your keypad.

2. Enter the User number (1-6), and push the # key.

3. Enter the 4 digit 236I - WRX User Pin Number, located on the white sticker near the connector on the receiver module,

and then push the # key.

4. Enter the new PIN again and push the # key.

Note: This will make the Master PIN number the same as the User PIN of your receiver. User 1 can use his Master

PIN to delete the PIN's of Users 2-6. Follow steps 1 through 4 for changing a User PIN. To delete a user PIN, enter

4 zeros in place of a new PIN number in steps 3 & 4.

If the new PIN is accepted, the keypad will beep twice. If you make a mistake while programming, or if the system

rejects the new PIN, the keypad will beep five times. Try again if necessary.

If no key is pressed for 5 minutes, the system will automatically exit the programming mode.

5. Exit the programming mode by pushing the *key, then the # key.

TO ENTER THE NEW PIN NUMBER

236i -