Wiring - AudioBahn ABC525V Operating Instructions Manual

Wiring

Wiring
Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may
easily be severed and can cause damage to your system should any bare wires come in contact with the
vehicles chassis.
Makes sure that your audio system is off while installing and connecting your new Audiobahn Speakers.
Failure to do so could result in damaging the speaker beyond repair. This is not something that would be
covered under the manufacturer warranty.
Be sure to route the wires to the speakers with the insulated terminal ending at the speaker. This will insure a
good contact with the speaker. If you need to shorten the speaker lead, do so on the opposite end of the
insulated terminals or the bare end.
Be sure the polarity is correct at all times. The speaker leads are color coded for negative and positive. Make
sure that the leads connected to the positive terminal of your amplifier or source unit is correctly connected to
the positive terminal of the speaker.
To insure long-term reliability all bare wires and wire-to-wire connections should be soldered and insulated
with heat shrink or electricians tape. Under no circumstances should you leave any bare wires uncovered, as
this can and will lead to the failure of your speakers and possibly other components.
When mounting in a door it is imperative to have the right amount of slack in the connecting wire as to not get
crimped or torn when the door is opened or closed. Avoid areas of the door jam that pinch. This will cause
damage to the speaker and other components over long-term use.
Once the speaker wiring is complete, you can connect the opposite end to the amplifier or source unit. Again,
be sure to observe correct polarity. Solder and wrap all stripped connections.
9