Table of Contents
Advertisement
Contact Us
If a problem should arise with the sampler or controller, please contact
Sentry at the number listed on the screen as shown below .
Configuration
This selection is password protected and is for factory use only .
Software
The Software screen lists the revisions for the loaded software .
Alarm Function
The Alarms Screen records all alarms with a time and date stamp along with
a description of the alarm .
Press the soft key next to the screen arrow (top Left) twice to get the alarm
function keys . At this point, the function keys will no longer perform the
function described on the keys; they have been switched over to the Alarm
Functions .
Pressing F1 (AUTO) will acknowledge the alarm: F2 (Remote) will clear the
alarm . If multiple alarms are active, F3 (OFF) will acknowledge all of the
alarms and F4 (Purge) will clear all of the alarms . Acknowledging the alarm
maintains the record on the alarm screen . Clearing an alarm removes it from
the alarm screen .
If the condition causing the alarm is still present, acknowledging or clearing
the alarm will not affect the condition and the program will continue to
react to the alarm state .
Purge Function
Some samplers have a purge option . The Purge command key on the controller allows manual activation of the Purge
solenoid . The solenoid remains energized and air flows through the sampler for as long as the Purge key is held down .
Stopping the controller
To stop the program and return the sample probe to the home position, press the OFF key . The sampler will finish its
current cycle and then return to the home position .
Sentry SBC Controller
Original Instructions
15
Advertisement
Table of Contents
