Light Distribution - Cooper Lighting Streetworks TRU Tribute Installation Instructions Manual

6.

Light Distribution

Some of the reflector options are directional
● ●
oriented. The reflector can be rotated in 90°
increments. Loosen reflector mounting screws
and rotate reflector to desired orientation and then
retighten the mounting screws. (Figure 6.) Tools
required 1/4" socket.
7 .
Wiring
Important: Dual voltage and multi-tap ballasts
● ●
are factory-wired for a specific voltage input as
specified. Before installation, make certain supply
and ballast voltages are compatible. For use with
other line voltages, splice black lead from the quick
disconnect plug with desired voltage lead from
ballast. Cap off un-used lead with wire nut.
Wire leads are to be routed from housing to pole.
● ●
All wiring connections are to be made in the pole.
Wire the fixture voltage leads to the supply voltage
lead; fixture common lead to the supply neutral lead;
and the fixture ground lead to the supply ground
lead. If fixture is supplied with the ballast tray option,
re-connect the polarized plug and replace the ballast
tray.
8. Photocontrol Receptacle
Loosen the two flathead screws to allow rotation of
● ●
the receptacle. Insert screwdriver into center slot
and rotate receptacle until indicator arrow points
north. Retighten screws. Plug the photoelectric
control into receptacle and twist into locked position.
The photocontrol must contain a soft, resilient
gasket fastened to the bottom surface to assure a
proper weather seal between the control and the
receptacle.
N ote: The orientation procedure is only required for
photocontrols which specifically require the cell to be
aimed north. Otherwise factory orientation will work.
Follow the directions recommended by the supplier
of the photocontrol for proximity to light sources.
Lighted signs, building surface reflection, floodlights,
tree branches, etc. May affect final position of the
photocontrol. (Figure 7 .)
9.
Lamp installation
Open fixture door. Install the lamp by grasping it
● ●
close to the base and rotating clockwise, tightening
securely to engage socket center contact. Close the
fixture door.
Do not use lubricants on lamp base or socket as this
N ote:
will cause damage and void warranty.
10. Reflector and Lens Cleaning
Open fixture door, dust reflector with soft, clean
● ●
dry cloth. Do not use alkaline or acidic cleaners on
reflector surfaces. Clean lens with non-abrasive
glass cleaning solution.
A regular maintenance schedule should be followed
N ote:
to retain optimal light output and reduce heat
retention.
Figure 6.
Loosen
Figure 7.
COOPER LIGHTING SOLUTIONS
Installation Instructions – TRU Tribute
IB500022EN
Installation instructions
5