Table of Contents
Advertisement
WARNING!
Turn off your power when adding or removing expansion cards or
other system components. Failure to do so may cause severe
damage to both your motherboard and expansion cards.
2-1
Hardware Installation Steps
Before using your computer, you had better complete the following steps:
1. Check motherboard jumper setting
2. Install System Memory (DIMM)
3. Install Expansion cards
4. Connect hard disk and front panel /back panel cable
5. Connect ATX Power cable
6. Power-On and Load Standard Default
7. Reboot
8. Install Operating System
9. Install Driver and Utility
2-2 Jumper Setting
(1) JP1 (3-pin): KB/MS Power on Function Enabled/Disabled:
(2) JBAT1 (3-pin): CMOS RAM Clear
A battery must be used to retain the motherboard configuration in CMOS RAM.
Note: When should clear CMOS
1.
Troubleshooting
2.
Forget password
3.
After over clocking system boot fail
WARNNING! Please remove or turn off the power supply before CMOS clear.
Following these steps to clear CMOS:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 2-3 for a few seconds
4.
Return JBAT to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
Chapter 2
Hardware Installation
JP1
1-2 Closed: KB/MS Power ON Disable (Default)
Keyboard /Mouse Power On Function Setting
JP1
2-3 Closed: KB/MS Power ON Enabled
3
Advertisement
Table of Contents
