Reversible air con 12 000/13 000 btu in cooling mode (37 pages)
Summary of Contents for Telefunken TEALCE-12CHSA
Page 1
SPLIT-TYPE ROOM AIR CONDITIONER Telefunken 9155 TEALCE-12CHSA OUTDOOR UNIT - COOLING/ HEATING INSTRUCTION MANUAL This instruction manual contains important information and recommendations that we would ask you to comply with to obtain best results from air conditioner. Thank you once again.
Page 7
NAMES OF PARTS INDOOR UNIT INDOOR UNIT Description Front panel Air filter Optional filter (if installed) LED Display Signal receiver Terminal block cover Ionizer generator (if installed) Deflectors Emergency button Indoor unit rating label ( Stick position optional Airflow direction louver Remote controller OUTDOOR UNIT No.
Page 8
INDOOR UNIT DISPLAY Function This symbol appears when the unit is power on POWER SLEEP mode SLEEP (1) Lights up during Timer operation when the air conditioner is operational Temperature display (if present) (2)Displays the malfunction code when fault /Error code occurs.
Page 10
REMOTE CONTROLLER Buttor Function (TEMP UP) Press it to increase temperature / time setting. (TEMP DN) Press it to decrease temperature/ time setting. ON/OFF Press it to start or stop operation. To select the fan speed of auto/low/mid/high Press it to set auto-off timer. TIMER SLEEP To activate the function...
Page 11
Mode MODE TIMER Temp Swing SLEEP DISPLAY Sleep Display Timer SWING SWING Mute Turbo I FEEL 18.13 21.23 MUTE HEALTH IFEELC LEAN TURBO I SET Mildew Health HEALTHY DISPLAY ANTI-MILDEW CLOCK HEALTHY DISPLAY SWING MODE TIMER SLEEP MODE TIMER ON/OFF SLEEP DISPLAY SUPER...
Page 12
REMOTE CONTROLLER Remote controller DISPLAY Meaning of symbols on the liquid crystal display Symbols Meaning FEEL mode indicator COOLING indicator DEHUMIDIFYING indicator FAN ONLY OPERATION indicator HEATING indicator SIGNAL RECEPTION indicator TIMER OFF indicator TIMER TIMER ON indicator TIMER AUTO or AUTO FAN indicator (FLASH) (FLASH)
Page 19
OPERATING INSTRUCTIONS I SET function(Optional) In each mode of COOLING/HEATING/FAN/DRY, adjust the temperature(COOLING/HEATING), fan speed (COOLING/ HEATING/FAN)and swing as your favourite, then keep pressing "I SET" button over 3 seconds until "AU" appears on the display and the background of display change to lighting, the remote controller will run and remember these settings.
Page 20
The air conditioner is programmed for comfortable and suitable living conditions as below if used outside the conditions, certain safety protection features might come into effect.,...
Page 27
4. For R32/R290 refrigerants, mechanical connectors should be outdoors. The connectors should be outdoors...
Page 29
INSTALLATION MANUAL---Installation of the outdoor unit ELECTRICAL CONNECTIONS wiring diagram on the back of the cover 1. Remove the handle on the right side plate of outdoor unit. 2. Connect the power connection cord to the terminal board. Wiring should fit that of indoor unit. 3.
Page 31
(Start from 5m) (2)The total charge amount should under the maximum according to the table GG.1 in page 20.