Technical Data - Zanussi ZBA32050SA User Manual

Problem
The temperature in the appli-
ance is too low/too high.
All the temperature setting
LEDs flash at the same time.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service Centre.

TECHNICAL DATA

PRODUCT INFORMATION SHEET
Trade Mark
Model
Category
Energy efficiency class
10
Possible cause
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The door has been opened
often.
The "QuickChill function" is
switched on.
There is no cold air circula-
tion in the appliance.
An error has occurred in
measuring the temperature.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Add less food products at the
same time.
Open the door only if necessary.
Refer to "QuickChill function".
Make sure that there is cold air
circulation in the appliance.
Contact the nearest Authorised
Service Centre. The cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible.
Zanussi
ZBA32050SA 923581011
1. Refrigerator with one or more fresh-
food storage compartments
A+