Important Notes - Outbound CTC201009-1 Owner's Manual

Hangout
6-PERSON CABIN TENT
Product No. 076-5962-0
Model No. CTC201009-1
ASSEMBLY INSTRUCTIONS

IMPORTANT NOTES:

* Assemble your tent before camping to become
familiar with the assembly.
* Two people are recommended for setup.
* Select a clean, level area for the campsite, free
of debris and sharp objects, away from any
natural watercourse.
* Use of a ground cloth is recommended to
prolong the life of the tent floor and provide
additional insulation and moisture protection.
* To prevent damage to the zippers, unzip the
doors and windows of the tent prior to
disassembly, allowing air to move freely.
* Seam-seal the inside stitched seams of the tent.
This will improve weather resistance. This
product is available in sporting goods
departments. Discolouration may occur if
applied to outside seams.
* Guy lines must be used for proper function.
Step 3 : Spread out tent and assemble roof
1) Spread out the tent flat, floor side down.
2) Use the illustration below and the line drawing in Step 4 as a guide.
3) Locate main pole sleeves and insert tent poles (A) so the poles cross at the centre of the tent.
Carefully place the ends into the corner connectors, forming an arch.
4) Insert pole (B/Grey) through the middle sleeve and attach to pre-attached connectors at the
middle of the tent, forming an arch.
5) Make certain all poles are locked in the connectors.
B
A
A
A B
A
Step 1: Verify package contents
Tent : 1
Rainfly : 1
Connectors : 6
( Pre-attached)
2 way
Steel Poles : 6 total
( ) denotes colour coding
(C) Middle Leg Poles - 2 (Red)
(D) Leg Poles - 4
Fibreglass Poles: 3 total
(A) Roof Main- 2
(B) Roof Middle (Grey) - 1
Tent Stakes : 12
Step 4 : Raise the tent
1) Place leg poles (D) at the front corners of the tent and insert the top of the pole into the
bottom of the corner connectors on the tent. Place the bottom of the leg poles (D) into the
O-ring pin at each corner stake loop.
2) Repeat for middle leg poles (C/Red).
3) Repeat process at the back of the tent.
4) Attach the plastic clip at mid-wall to the leg poles.
C
D D
D
D
C
1
Step 2 : Assemble poles
1) Assemble steel poles by placing tapered
ends into the adjacent sections.
(D) Leg Poles - 4
(C) Middle Leg Poles (Red) - 2
2) Assemble the tent poles by placing
fibreglass sections into the metal ferrules.
(A) Roof Main- 2
(B) Roof Middle (Grey) - 1
4
CTC201009-1 9/19