DANGER! *Ensure that the switch to be serviced matches the switch discussed. If the breaker to be serviced does not match, please call CBS ArcSafe® for more information regarding switching applications for your particular model of switch. 1.1 RSA-102 Alignment Locations for Breaker Installation...
Page 3
ATTENTION The numbers depicted on the RSA-102 correspond to the breaker alignment locations from Figure 1. Figure 2: RSA-102 Alignment locations. The locations in Figure 2 need to align with the numbered locations in Figure 1, slight adjustments need to be made for proper operation. These adjustments will be discussed in the next section of the manual.
Page 4
1.2 RSA-102 Adjustment Locations To widen the RSA-102, loosen the screws of the following locations and slide the left support outward. This adjustment will help the RSA-102 fit more securely between the breaker door and the left hinge, as seen in the image below.
Page 5
Adjustments will need to be made to the two motor stops above to limit the travel of the handle. This will keep the RSA-102 to from damaging the ON/OFF Switch. They can be adjusted with an Allen wrench then raised or lowered to the proper height.
Page 8
P.O. Box 550 Argyle, TX 76226 Tel: 940-382-4411 Fax: 940-382-9435 Website: www.CBSArcSafe.com Email: info@CBSArcSafe.com DANGER! *Ensure that personnel using this equipment are adequately trained in the operation of the switchgear they are planning to work with; that they are correctly stationed outside the arc flash boundary;...