Ecco ET0010 Series Installation And Operation Instructions Manual

IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user. ECCO is not responsible for the misuse of products by un-authorized
personnel.
WARNING!
Risk of fire and burns. Do not open, crush, expose to heat above 120°F(50°C), incinerate or short terminals. Do not store, use
or charge in locations that may reach or exceed 120°F(50°C). Never charge while unattended. Do not expose battery to water or liquids. Follow
manufacturer's instructions.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are essential to
ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arc-
ing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output performance of
the system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system with-
out losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle op-
erator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment
doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal. Never take the
right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, driving against traf-
fic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws re-
garding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and regulations. The man-
ufacturer assumes no liability for any loss resulting from the use of this warning device.
Specifications:
Size: Kit
2.8"D.
Light only
Weight: Kit
Light only
Charging Voltage:
AC/DC Adapter:
Cigarette Adapter:
Temperature Range:
Installation and Operation Instructions
14.5"H. x 15.0"W. x
4.7" Dia. x 1.7"D.
6.0 lbs.
0.6 lbs.
100-240 VAC
12-24 VDC
-22° to 122°F
-30° to 50°C
ET0010 SERIES RECHARGEABLE
WARNING DEVICE KIT
Prior to use:
Carefully remove the unit from its packaging. Examine the unit for transit
damage. If damage is found, return the product to your local dealer for
warranty replacement. Do not use damaged or broken parts.
1. Fully charge the flares before first use. The charging indicator light on
each flare indicates the unit is charging.
2. The flares should be charged at least once every three months when
not in regular use.
3. Only use the chargers provided with this kit.
Installation and Operating Instructions:
Warning: THE MAGNET MOUNT IS INTENDED FOR USE ON
STATIONARY VEHICLES ONLY. REMOVE AND STORE WHEN
VEHICLE IS IN MOTION. Set the desired flash pattern according to the
chart and attach the unit to a flat, clean, dry magnetic surface. The vis-
ibility of the flash should be taken into consideration in the selection of the
mounting location.
Page 1 of 2