Advertisement
4.8 During SSB transmission the peak power of the TCVR may exceed the allowed
maximum driving power of the transceiver! Use The POWER knob on the TCVR
in this case.
4.9 You can not switch the Amplifier to transmission if Ua, UG2, or UG1 voltage is
missing (You can control these voltages on LEDs of control unit.)
4.10 You can use for external units the TX-GND and RX-GND contacts of G2
stabilizer PCB. The delay is 100mSec from RY1 input relay.
11
Advertisement
