Table of Contents
Troubleshooting
Related Manuals for Tanco Autowrap 1300 S
Summary of Contents for Tanco Autowrap 1300 S
- Page 1 TANCO AUTOWRAP 1300 S & SM OPERATORS HANDBOOK WD66-1300 S-M1205 Tanco Autowrap Ltd. Royal Oak Road Bagenalstown Co. Carlow Ireland Tel.: +353 (0)5997 21336 Fax: +353 (0)5997 21560 E-Mail: info@tanco.ie Internet: www.tanco.ie...
- Page 2 Tanco Autowrap 1300 S Operator’s manual GUARANTEE Subject to hereunder provided, the sellers undertake to correct either by repair or at their election by replacement any defect of material or workmanship which occurs in any of its goods within twelve months after delivery of such goods to first user, with the exception of contractors or commercial users when warranty period is six months.
-
Page 3: Table Of Contents
Tanco Autowrap 1300 S Operator’s manual USER'S MANUAL TANCO AUTOWRAP 1300 S CHAP. CONTENTS PAGE INTRODUCTION SAFETY PRECAUTIONS GENERAL INFORMATION ON BALEWRAPPING SETTING UP / MOUNTING OF THE MACHINE EMERGENCY STOP* (Instant stop) MOUNTING OF PLASTIC FILM CONTROLLER MANUAL SPEED SETTING OF THE WRAPPING ARM ADJUSTING THE OVERLAP 10.0... -
Page 4: Tanco Autowrap 1300 S
Tanco Autowrap 1300 S Operator’s manual TANCO AUTOWRAP 1300 Bale wrapping machine Wrapping arm motor Main frame Wrapping arm Speed control Film Dispenser Tower Rollers Lifting Eye Bale stop roller Emergency stop* Cut and Start... -
Page 5: Introduction
Then it's possible to stack the bales upon each other. TANCO AUTOWRAP 1300 is designed to wrap bales of grass, hay or straw, with nominal diameter of 1.1-1.5 m, and weights up to (1200kg). The machine was developed and has been improved since it’s beginning in 1986, and is now a very reliable and safe machine with high... -
Page 6: Safety Precautions
Fig.: 2-1 SAFETY PRECAUTIONS. Tanco Autowrap Ltd does not take responsibility for damages that may occur to machine, persons or other equipment, because of the machine NOT being used as described in this manual, or because of the safety precautions NOT being followed. - Page 7 Operator’s manual DANGEROUS AREAS. Tanco Autowrap Ltd has given the safety to the operator the highest priority, but it is still impossible to secure oneself of every danger area on the machine. Therefore we will now go through some of the dangers that can occur when using the Tanco autowrap bale wrapper.
- Page 8 Tanco Autowrap 1300 S Operator’s manual SQUEEZE DANGER BETWEEN ROLLER ARMS AND MAIN FRAME, OUTWARDS. When loading or unloading a new bale, the roller arms move outwards. Beware of the danger. Keep clear of this area. SQUEEZE DANGER CAUSED BY CUT AND START UNIT.
-
Page 9: General Information On Balewrapping
Tanco Autowrap 1300 S Operator’s manual GENERAL INFORMATION ON BALE WRAPPING. THE PRINCIPLE. The advantages of round bale silage are many, and include fewer feed units, a flexible harvesting system, large capacity and the possibility of selling feed units. In principle, the same fermentation processes occur whether the fodder is placed in a silo or pressed into bales and packed in plastic, i.e. - Page 10 Tanco Autowrap 1300 S Operator’s manual STORAGE LOCATION. Care should be taken in finding a suitable location for the storage of bales. The storage location should preferably be prepared before the bales are laid out. An elevation close to well-drained roads is recommended.
-
Page 11: Setting Up / Mounting Of The Machine
THREE POINT LINKAGE. TANCO AUTOWRAP 1300 is intended for rear mounting to the three point linkage, category 2. When attached to three point linkage, make sure the machine is level across the tractor. Tighten up and lock the lifting arms so there is no sideways movement. - Page 12 Tanco Autowrap 1300 S Operator’s manual CONTROL BOX 1300 S 1300 EH Controller 1300 S controller – Wrap counter also operates Cut and Tie. ELECTRIC CONNECTION. The electrical supply cable for the 1300S machine is terminated in a “Cobo” power plug, this should be used where a compatible socket is available on the tractor.
- Page 13 If any problems should occur, it is most likely that the failure is in the quick-couplers on the tractors pressure and return-connections. Make sure that both the male and the female-couplers open properly for the oil flow. Check Your TANCO AUTOWRAP bale wrapper has been tested in practical operation in approx. 2 hours at the factory.
-
Page 14: Emergency Stop* (Instant Stop)
Tanco Autowrap 1300 S Operator’s manual EMERGENCY STOP*. The machine is equipped with a safety guard on the wrapping arm, and its operation must be tested before work itself is started. The emergency stop* is to prevent the wrapping arm from damaging people and objects, when the machine is started and during the wrapping process. - Page 15 Tanco Dual Stretch Dispenser Some Tanco Autowrap machines can optionally be fitted with a patented dual stretch gear system. This system enables a quick change of stretch levels on the Film Dispenser. If the bolt (1) is fitted in position 2, the top set of gears provide the stretch (70%).
-
Page 16: Controller Manual
Tanco Autowrap 1300 S Operator’s manual 7.0 S Controller Manual 7.1 Introduction What can it do ? 7.2 The control switches 7.3 Using the instrument 7.3.1 Channel 1 - Current/Target Wraps display 3.1.1 Manually reset Current Wraps to zero 7.3.1.2 Programme Target Wraps 7.3.1.3 Programme Early Warning Alarm... - Page 17 Tanco Autowrap 1300 S Operator’s manual Introduction The instrument has 6 channel functions with an illuminated 4 digit LCD display, 5 switches to control all functions and an internal alarm. An external alarm is optional. The instrument is normally powered on via the vehicle ignition circuit and recalls the function displayed when the instrument was last used.
- Page 18 Tanco Autowrap 1300 S Operator’s manual 7.3.0 Using the Instrument 7.3.1 Channel 1 - Current/Target Wraps Display Press to select The left-hand section shows the current number of wraps and the right hand section shows the target number. When the current number = Target number, the alarm will sound for 2 seconds and the display will flash. (If set, the early warning alarm sounds beforehand).
- Page 19 Tanco Autowrap 1300 S Operator’s manual 7.3.1.3 Program Early Warning Alarm An early warning alarm can be programmed to sound from 1 to 9 wraps before the target number is reached. Depending on the setting, the alarm will sound long beeps for up to 8 wraps, short beeps for the final wrap, and then a continuous beep for three seconds.
- Page 20 Tanco Autowrap 1300 S Operator’s manual 3.2.3 Reset a Store Total Press to select Select the desired store total (A – H). Press and hold. 7.3.3 Channel 3 – Part Total When the bale wrap is complete, the part total is automatically advanced by 1. The part total can be reset at any time 3.3.1...
- Page 21 Tanco Autowrap 1300 S Operator’s manual 7.3.5 Channel 5 - Bale Wrapping Rate Displays number of bales wrapped per hour. The time period over which the rate is averaged may be re-started at any time. Display Bale Wrapping Rate Press to select...
- Page 22 Film Break Sensor – OROGRAMMING LEVEL 2 7.3.8 Programming Level 2 The 1300 S features Automatic Cut and start operation through the control unit. The 1300 SM also has an autostop feature which holds the joystick in position and automatically releases it at the end of the wrap sequence. The settings of these features are programmable in Level 2.
-
Page 23: Speed Setting Of The Wrapping Arm
Tanco Autowrap 1300 S Operator’s manual SPEED-SETTING OF THE WRAPPING ARM. Start the tractor and let it run at approx. 1000 revolutions per minute. Lift the machine clear of the ground. The oil flow to the machine is adjusted by two wheels which are situated on the front the machines valve block. -
Page 24: Operating Instructions
Tanco Autowrap 1300 S Operator’s manual 10.0 OPERATING INSTRUCTIONS. We shall now go through a complete wrapping process, from loading to storage place, and explain the practical use of Tanco autowrap 1300. 10.1 Fitting roll of film. Fig.: 10-1 Fig.: 10-2 When loading a plastic roll, first ensure the top cone (2) is pushed up to latched position, then push back the Stretch rollers (3) until held in position by locking catch (4). - Page 25 Tanco Autowrap 1300 S Operator’s manual 10.4 START. The plastic film end has to be locked in the Cutter/Film holder or tied to the bale before starting the wrapping. Operate the tractors single acting hydraulic lever to start the arm turning. Remember the Reset button on the control unit must be pressed when the control unit is switched on first to allow the wrap arm to turn.
-
Page 26: Periodic Maintenance
Tanco Autowrap 1300 S Operator’s manual 11.0 PERIODIC MAINTENANCE. 11.1 BEARINGS. All ball-bearings are packed with grease, and do not need any more maintenance. 11.2 PRE-STRETCHER. If the machine is in daily use, the Gears under the plastic cover on the dispenser should be greased when needed. -
Page 27: Electric Circuit
Tanco Autowrap 1300 S Operator’s manual 12.0 ELECTRIC CIRCUIT DIAGRAM 1300S... - Page 28 Tanco Autowrap 1300 S Operator’s manual There are 3 basics which must ALWAYS be followed if the machine is to function correctly...
-
Page 29: Description Of Hydraulics
13.1 "OPEN / CLOSED CENTER" HYDRAULIC. The 1300 S machine uses the tractors own remote valves to operate the functions on the machine so no alteration is required to the machine to operate with ‘open or closed ‘ hydraulic systems. - Page 30 Tanco Autowrap 1300 S Operator’s manual S4 (VMP) Limits wraparm torque. S3 (VMT) Ensures gradual stop of wraparm. S1 (VBS) Ensures smooth running of wraparm in hilly conditions. Fig. 13-2 13.4 WRAPPING ARM VALVE BLOCK. The wrapping arm valve block is attached to the wrapping arm motor, and includes 4 valves.
-
Page 31: Check Points Before Trouble Shooting
Tanco Autowrap 1300 S Operator’s manual 14.0 CHECK POINTS BEFORE TROUBLE SHOOTING. In this chapter we have some general check points that have to be examined first if something is wrong with the machine. In chapter 17.0 we have a more detailed trouble shooting. -
Page 32: Procedure Of Trouble Shooting
Tanco Autowrap 1300 S Operator’s manual 15.0 PROCEDURE OF TROUBLE SHOOTING. 15.1 SOLENOID VALVES. When checking if the Solenoid valves are receiving electric power, you do this in the following way: Unscrew the nut that holds the solenoid. The solenoid is easy to move without electric power. - Page 33 Tanco Autowrap 1300 S Operator’s manual 16.3 THE CUTTER WILL NOT CLOSE The cutter is closed with a hydraulic accumulator, the oil return through the free return connection to the tractor. Check the return coupling to ensure that it is not causing a restriction.
-
Page 35: Declaration Of Conformity
Tanco Autowrap 1300 S Operator’s manual 18.0 Declaration of conformity EC DECLARATION OF CONFORMITY ACCORDING To DIRECTIVES 89/392/336 /EEC AS AMENDED Manufacturer: TANCO ENGINEERING Co LTD BAGENALSTOWN CO CARLOW IRELAND CERTIFIES THAT THE FOLLOWING PRODUCT: TANCO AUTOWRAP 1300 SERIAL NO: To which this declaration relates, corresponds to the essential requirements of the Directive 89/392/336/EEC as amended.
Need help?
Do you have a question about the 1300 S and is the answer not in the manual?
Questions and answers