ZSX Breakout Board Manual
The ZSX
breakout board
is the first of its kind to include a full ATX PICO 24pin connector to directly power your motherboard, CPU,
and an HDD or SDD. Additionally, it features built-in fan hubs to power up to 10 fans. The ZSX is truly the single board for 100%
GPU mining rigs.
The ZSX is designed to be compatible with the Delta/Dell/Lite-On 1100W and 1400W server power supplies (picture on the left with
8 smaller pins) and are also backwards compatible with HP 750W, 1200W, 1500W, and Delta 2400W power supplies (picture on the
right with 6 smaller pins). These boards will automatically detect which model power supply it is currently connected to and adjust
itself for compatibility.
The notable known compatibility exceptions are part numbers 0TCVRR, 0GVHPX, and 0XCHHD, which are only compatible with
our older
X12
model. If you are ever in doubt, please refer to the extensive
specific model and part numbers.
Breakout Board Features
1: Connector slot. When connecting the breakout board to your PSU we recommend sliding in one corner of the slot from
the PSU at a 45-degree angle and then sliding the rest of the power bar into the connector slot. (Lubricant is not required,
but can be recommended. Apply on the PSU power bar and wipe away any excess prior to connecting the adapter.)
2: 4-pin Molex input. This is to allow remote access to manually or automatically cycle power on/off your power
supplies via our optional
remote management
breakout board compatibility list
module.
!!WARNING:
NEVER CONNECT THIS PORT TO YOUR
Parallel Miner's ZSX Breakout Board Manual |Revised Jan 2021
on our site to look for
1