Advertisement
FiBO® Model 250
Order of Calibration
The order of calibration for the FiBO 250 is as follows:
2D
Phase Shift
3D
Apex Offset
For a detailed description of this important process, please reference the FiBO 250 User's Guide
section of "Calibration Targets".
Measurement Setup
1. Select the appropriate adapter (e.g., FC, FC/APC, ST, SC, 1.25mm, 2.5mm) for your
application.
2. Place the adapter onto the kinematic mount. Confirm the orientation slot opposite the
thumb rest is aligned with the red alignment pin on the FiBO.
3. Insert the connector completely into the adapter. If applicable, align the key to the
adapter's keyway.
For detailed information on taking measurements and viewing results, please reference
the FiBO 250 User's Guide sections "Fiber Measurements Techniques and Parameters",
"Fiber Connector Measurements" and Viewing Measurement Results".
For customer support, please contact us at 651-481-9661 or email FiBO@prometoptics.com.
Promet Optics
Attaching a Connector Adapter to FiBO
Inserting a Connector
3
QS V3.1 05/17
Advertisement
