Advertisement
FiBO® Model 250
Software & Device Driver Installation
Your FiBO® 250 system includes a laptop. FiBOCode and the device
drivers are installed prior to shipment.
What's In the Box
FiBO 250 Interferometer
FiBOCode™ software
Laptop computer
One connector adapter
Calibration targets
Rugged case
USB 3.0 cable
Flash drive with manual
Setting Up FiBO
1. Connect FiBO directly to the
computer using the supplied USB
cable. FiBO must have a dedicated
USB 3.0 port. Do not use a USB hub.
2. Plug the A end of the cable into a USB
3.0 compliant port.
3. Plug the B end of the cable into FiBO
4. Note that demo/older FiBO systems
may use USB 2.0
Calibration
In order to have proper measurements, the FiBO hardware must be calibrated using the
included set of three calibration targets.
Do not touch the surface of the central portion of the alignment
target. It is delicate and can easily be damaged.
Promet Optics
2
QS V3.1 05/17
Advertisement
