For Your Safety - Beta 1555/QS Instructions Manual

Beta
We recommend using this machine after reading the instruction manual carefully, keeping to the instructions
provided therein.
Before each operation cycle, make sure that the machine is in good condition. If the operating conditions are
not safe enough or a failure should be reported, the machine should not be used.
• Do not make any structural changes to the machine. Do not replace the safety pin with a heavier duty one.
• Use only original spare parts.
• Use only forks suitable for the springs. Make sure that the springs fit into the forks. The springs must be centred into
the forks.
• The fork bolts must be screwed tight.
• The spring axis must always run parallel to the compressor axis. In particular, this must be the case with conical
and elliptical springs.
• During compression, neither the springs nor the forks must touch each other.
• When using pneumatic or electric tools, never exceed 180 Nm torque.
Operating Tips
The spring compressor is for use only on MacPherson springs. It is not designed for any other use.
Specifications
Compressor for MacPherson springs
Includes two sets of forks
Maximum load
Weight
Overall weight, including forks
Minimum opening
Maximum opening
Maximum working opening
Impact wrench with maximum torque
Standard Accessories
2 forks, ø 80-145 mm
2 forks, ø 145-195 mm
Special Accessories
Conical spring fork, ø 80-145 mm
Fork for BMW E39, E46 and Renault Mégane II
Fork for Mercedes C 203
Fork for Mercedes E 211 and Renault Mégane II
Operating Tips
• Remove the MacPherson spring guards.
• Choose the appropriate forks.
• Place the forks on the compressor, using the bolts supplied with the machine. Screw the Allen bolts tight. For your
safety, the bolts must be tight. Open the forks as needed to match the spring length, compressing as many coils as
possible.
• Place the compressor guard on a suitable vice.
• Fit the compressor onto the spring. Make sure that the springs have been properly fitted into the forks.
• Turn the handle with a pneumatic tool or a wrench as needed to release the upper support. Do not compress the
spring any further, because it might get deformed.
• Replace the protective spring cartridge and the upper support.
• Release the compressor and remove it.
INSTRUCTIONS
ART. 1555/QS
Shock absorber spring compressor

For your safety

2.250 kg (22.500 N)
5.2 kg
10.7 kg
41 mm
337 mm
295 mm
180 Nm
GB