Important Note - LeapFrog leapland Adventures Instruction Manual

OTHER NOTES
Static electricity may cause the HDMI Game Stick to malfunction. In cases
where the HDMI Game Stick is malfunctioning due to static electricity,
disconnect the Micro USB Power Cable, wait for 10 seconds, then
reconnect the Micro USB Power Cable to reboot the HDMI Game Stick.
FCC Compliance Statement
After completing the steps in the Initial Setup section, power on the
television. FCC e-labeling will be shown on the television for the U.S.
version of LeapLand Adventures™.
This screen confirms that this product complies with FCC regulations.

IMPORTANT NOTE:

If the problem persists, please call our Consumer Services
Department at 1-800-701-5327 in the U.S. and Canada, or email
support@leapfrog.com. Creating and developing LeapFrog
products is accompanied by a responsibility that we take very
seriously. We make every effort to ensure the accuracy of the
information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that
we stand behind our products and encourage you to contact us
with any problems and/or suggestions you might have. A service
representative will be happy to help you.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
10