Advertisement
by VIS-A-VIS, INC.
Option 1 - Using a Wireless Headset with the Headset Jack
A Sennheiser D 10 wireless headset can be plugged into either of the two jacks labeled "Headset" on
the front of the console instead of using a corded headset at these locations
Please note that if you are also using a desk microphone, it must be plugged
into the jack on the rear of the console on the opposite side from the headset.
1) Locate the "Sennheiser Crossover Cable" (P/N: SCC0312). This cable is made by
Vis-A-Vis and will be included with your wireless headset when purchased from Vis-
A-Vis. It is not a a Sennheiser cable. This cable has an RJ45 (ethernet)
connector on one end and a RJ9 connector on the other end.
2) Plug the end of the cable with the RJ9 connector into one of the two jacks labeled
"Headset" on the front of the console. Plug the other end of the cable with the RJ45 connector into the jack
labeled "Phone" on the rear of the Sennheiser wireless headset base station (color
coded green).
3) Adjust the Microphone volume on the rear of the base station to approx. 6. This can
be fine tuned later as needed.
TM
Supplemental Instructions
Using Sennheiser D 10 Wireless Headsets
with the Vitalinq 94A-07 Communication System
The information in this document is intended to provide guidance when
using Sennheiser D 10 wireless headsets with the Vitalinq 94A-07 Cath
Lab communication system. Illustrations shown in these instructions were
taken from the Sennheiser Instruction Manual. For a description of all
the features specific to the headset and for important safety
information, please refer to the manual that is included in your
wireless headset packaging. Should you require additional information
or have any questions, please call Vis-A-Vis Customer Service at
800-319-6014 or email Support@vitalinq.com.
7936 Camino Circle
VIS-A-VIS, INC.
Miami, FL 33143
800-319-6014
support@vitalinq.com
www.vitalinq.com
Last Revised: November 8, 2016
Advertisement
Table of Contents
Related Manuals for VIS-A-VIS Vitalinq
Summary of Contents for VIS-A-VIS Vitalinq
- Page 1 1) Locate the “Sennheiser Crossover Cable” (P/N: SCC0312). This cable is made by Vis-A-Vis and will be included with your wireless headset when purchased from Vis- A-Vis. It is not a a Sennheiser cable. This cable has an RJ45 (ethernet) connector on one end and a RJ9 connector on the other end.
- Page 2 See instructions on page 3. Your wireless headsets should now be functioning and capable of two way communication with each other and with any headset which is plugged into a “Headset” jack on the front of the Vitalinq console. Page 2...
- Page 3 To mute the headset, press the Audio button in. The microphone is muted and the LINK LED on the base station flashes red. To cancel muting, press the Audio button once more. The muting is cancelled and the LINK LED on the base station lights up blue.
- Page 4 (RJ45) connector on one end with two cables leading from it to a pair of ethernet connectors. 2) Plug the ethernet connector with the two cables attached to it into the jack on the rear of the Vitalinq console labeled “Yellow”.
Need help?
Do you have a question about the Vitalinq and is the answer not in the manual?
Questions and answers