Operation; Switching On And Off - Elem Garden Technic CBE1201 Original Instructions Manual

OPERATION

1. Before use, check that the tools in good working order and that the length of the trimmer line
is correct, as follows:
2. Ensure the switch is at the off position and disconnect the cable plug from the mains supply.
3. Remove the cover of the line cutting blade.
4. Examine the general condition of the tool. Inspect the guard, switch, supply cord and
extension cord. Check for loose screws, misalignment, and binding of moving parts, improper
mounting, broken parts and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs during operation, turn the trimmer off immediately and have the
problem corrected .Do not use a damaged tool and attach a label"DO NOT USE"to the tool.
1). Ensure that you are on a flat surface and have secure footing.
2). Check that the line touches or goes beyond the edge of the guard.
3). If the line is too short, pull on the nylon line and repeatedly press the button of spool (9) until
the line reaches the edge of the guard. Pull the other line until it reaches the edge of the guard.
WARNING. For your own safety when adjusting the length of the line, avoid coming into contact
with the line cutting blade which is fixed to the guard. It is extremely sharp. Keep your hands
well away from this area.

SWITCHING ON AND OFF

1) Connect the plug to the supply.
2) To switch on, you need to push the safety lock-off button (4) and then actuate the switch
trigger (5).
3) To switch off, release the switch trigger.
WARNING. The tool runs for approximately 5 seconds after it has been switched off. Let the
motor came to a complete stand still before setting the tool down.