Instructions For Use Of On-Call Via Verizon Or Att; Verizon Access - Spectros T-Stat 2.0 User Manual

Instructions for Use of On-Call via Verizon or ATT

WARNING: Do not engage Wi-Fi or use cell modems in areas where emissions
1. Power up the T2 and wait for the self-test to finish its checklist.
2. On the home screen, click on "Options". In the following page, there will be a
number of options on the left panel.
3. Click on the button that says "Oncall Access". This will be the 4th from the top.
4. On the page that appears, there will be 3 options to choose from: Wi-Fi Settings,
Verizon Modem and AT&T Modem. Follow instructions given below to setup your
connection.

Verizon Access:

Connect the Verizon Modem to the USB port at the back of T2 and wait for the Status
1.
button to turn into a solid green light.
When the light is solid, click on the "Verizon Modem" tab on top of the page.
2.
Wait for a few seconds while Verizon establishes a connection. The following page will
3.
appear when the modem is ready to transmit.
To verify, check the internet connection icon at the bottom of the page. It should be
4.
green if there is an active connection, and grey when the connection is lost.
Once the connection is established, the device is ready for transmission. To disconnect,
5.
navigate to the connection page above and click on the "Disconnect" button.
NOTE: If the LED on the modem doesn't become a solid green for a prolonged period of time,
try moving the device to a more open area with better cellular reception.
Spectros Medical Devices Inc.
T-STAT 2.0 User Manual
could interfere with critical wireless monitors. Follow hospital
policy.
Page 25 of 44 Rev B