Advertisement
5.3.
ASSEMBLING THE REEL Refer to fig.3
5.3.1 Locate the reel cross pieces (9) into the slots in the reel ends (6) and push into place until they lock in position.
5.4.
ATTACHING THE CRANK HANDLE Refer to fig.4
5.4.1 Fit the crank handle (10) through the right hand side stand holder (2) and through the reel end (6) so that the threaded portion protrudes
from the reel end (6).
5.4.2. Screw the crank handle nut (11) onto the threads of the crank handle (10) and tighten.
5.5.
ATTACHING THE HOSE CONNECTIONS Refer to fig.5
5.5.1 Fit the angled hose connection (13) through the reel end (6) and the left hand side stand holder (1) so that the threaded portion protrudes
from the left hand side stand holder (1).
5.5.2. Screw the fixed hose connection (12) onto the threads of the angled hose connection (13) and tighten. The hose trolley is now ready for use.
6. OPERATION
6.1.
FITTING THE HOSE
6.1.1. Attach the hose to the angled hose connection (13), and wind it onto the reel taking care to guide the hose from one side of the reel to
the other to prevent bunching of the hose.
6.1.2. Attach the supply hose to the fixed hose connection (12).
6.2.
EXTENDING THE HOSE
6.2.1. Firmly hold the trolley and pull the hose from the reel. Pulling the hose directly from the reel may cause the hose trolley to tip over.
6.3.
RETRACTING THE HOSE
6.3.1. When retracting the hose, always make sure the water supply is turned off, make sure there is plenty of space to perform the task.
Free the hose's path of any obstructions and check for kinks in the hose before reeling in.
6.3.2. Rotate the crank handle (10) clockwise whilst firmly holding the trolley taking care to guide the hose from one side of the reel to the
other to prevent bunching of the hose.
7. STORAGE
7.1.
STORAGE
Prior to storing the hose and reel, ensure that the water supply is turned off and any accessories are disconnected. Drain as much
water from the hose as possible. Place in a dark, safe, dry, childproof location, where the hose will be protected from frost.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.3
01284 703534
Original Language Version
fig.4
sales@sealey.co.uk
fig.5
www.sealey.co.uk
GH60 | Issue 2 (H,F) 13/08/2019
Advertisement
