1. Manuals
  2. Brands
  3. Fogo Montanha Manuals
  4. Stove
  5. Round
  6. Instruction manual

Fogo Montanha Round Instruction Manual

Firewood round stove
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Instruction Manual
English
Firewood Round Stove
Round
Mod. 934-B

Advertisement

Table of Contents
loading

Related Manuals for Fogo Montanha Round

Summary of Contents for Fogo Montanha Round

  • Page 1 Instruction Manual English Firewood Round Stove Round Mod. 934-B...
  • Page 2 * All local regulations, including but not limited to national and European standards, must be observed when installing, operating and servicing the unit; * FOGO MONTANHA free standing fire units are tested and found to be in compliance with the EN 13240:2002 + EN 13240:2002/A2:2005 + EN 13240:2002/AC:2006 + EN 13240:2002/A2:2005/AC:2006 standards;...

  • Page 3: Table Of Contents

    Contents Page Introduction ............................... 4 Fogo Montanha ............................4 Technical Specifications ..........................5 Unit Components ............................7 Components ............................7 Optional ............................. 7 4.2.1 Fume outlet ..........................7 4.2.2 Connecting the extarnal air inlet ....................8 4.2.3 Firewood base door ......................... 10 4.2.4...

  • Page 4: Introduction

    1. Introduction Thank you for choosing a FOGO MONTANHA free standing fire unit. In order to get the best performance from your unit, while complying with the applicable eco-standards, carefully follow the installation and operation instructions provided in this manual. Any damage to the unit due to non-compliance with the instructions shall void the warranty.

  • Page 5: Technical Specifications

    3. Technical Specifications FOGO MONTANHA's free standing fires are designed as interior heating appliances. These units are easy to install and do not require any kind of finishing, thus promoting their seamless integration with the room setting. * Technical specifications across the free-standing fire range:...
  • Page 6 Front Side Back Figure 2 - General dimensions of the Round Features Stove Round Flue Ø (mm) Ø 150 int. Rated power (kW) Performance (%) CO emission (13%O ) (%) 0,073 emission (vol.-%) 8,67 ° Average temperature combustion products (...

  • Page 7: Unit Components

    N – Secondary air O – Fume baffle P – Double baffle Q – Fume outlet Figure 3 – Components of the Round stove 4.2 Optional 4.2.1 Fume outlet The stove has the option of using the smoke outlet horizontally or vertically, the latter being the way in which the stove is prepared for the customer.

  • Page 8: Connecting The Extarnal Air Inlet

    you place wood very dry and thin, closing the door of the stove until it is well lit. Then you can fully load the equipment. 4.2.2 Connecting the external air inlet If you wish to use the external air inlet, you should purchase this optional kit separately. The purpose of this optional accessory is to establish a connection point between the equipment and the outside ambient air, thus installing a more suitable piping for this purpose.
  • Page 9 After removing the cover, place the optional air inlet kit as shown in Figure 6, tightening the kit with the 4 nuts that come in the package. Placement outside air inlet kit. Figure 6 – Rear view of the equipment; placement of the outside air inlet kit The cover that you removed to place the external air inlet kit must be placed in the lower part of the equipment, as shown in Figure 7, to do this you must loosen the 3 screws that fix the base to the equipment to have access to the place where you place the cover.

  • Page 10: Firewood Base Door

    Outdoor air inlet kit, from the rear of the base. Outdoor air inlet kit, from the bottom of the base. Figure 8 – External air inlet, (M) section to be removed for external air inlet The external air inlet kit must be placed in the lower area of the equipment, as shown in Figure 9. To do this, loosen the 3 screws that fix the base to the equipment and apply the external air inlet kit with the 4 nuts that come in the package.
  • Page 11 Using a key, carefully fold the tab on the right side of the base, so that it is perpendicular to the side, as shown in Figure 10. Figure 10 – Preparation of the base of the equipment, to place the door Place the magnet on the bent tab and secure it with the nut.

  • Page 12: Top Cover In Stone

    Place the door on the base by first inserting the door axes in the upper hole of the base and then in the lower hole of the base, as shown in Figure 12. Place the upper axis of the door, on the Place the lower axis of the door on Tilting to place the door on the the lower axis of the base.

  • Page 13: Assembly And Disassembly Of Casings

    Horizontal smoke outlet - Place and fix the board that comes with the stone worktop with two screws and loosen the two screws of the machine 1 cm where the stone worktop will fit, as shown in the following pictures. Figure 14 –...
  • Page 14 Loosen the screws on the upper part of the casings, as shown in Figure 16, so that the casings are free. Figure 16 – Disassembly of the side casings in the equipment Disassembly direction, to remove the casings, follow the direction of the arrows, as shown in Figure Direction of disassembly of the right-side casing.

  • Page 15: Installation

    Figure 18 – Centering of the side casing with the equipment Then, tighten the casings in the upper area of the equipment by tightening the screws as shown in Figure 19. Figure 19 – Assembly of the side casings in the equipment 6.
  • Page 16 Figure 20 – Piping and chimney installation  The flue must be free from obstructions, and preferably maintain the same round diameter all the way through, from the unit to the output. To ensure proper operation, the diameter must be compliant with each model specifications (refer to the catalogue).
  • Page 17  The chimney should not be close to surrounding tall trees, walls or buildings as these could cause downdraughts.  The chimney must be properly insulated. The chimney lining must be free of cracks or fissures and be made of refractory cement or other high temperature resistant material. If the chimney is not properly insulated, the flue must run all the way up the chimney.

  • Page 18: Installation Space Requirements

    NOTE: The flue must be safely and securely connected to the outlet pipe of the unit and the chimney must be swept at least once a year in accordance with local regulations. 6.2 Installation space requirements * The unit should stand on a masonry hearth made of refractory bricks or other type of non-combustible material;...

  • Page 19: Instructions For Use

    7. Instructions for Use 7.1 Fuel The stove only burns wood. It will give the best results if you use dry firewood with 12% to 16% humidity. Always use firewood with a moisture content below 20%. The cut firewood should be kept and ventilated in a covered place for at least 1 year and preferably for 2 years.
  • Page 20 few hours. However, we do not recommend this procedure because incomplete combustion creates smoke which, when condensed, deposits tar in the stove, chimney and glass panel. An accumulation of tar becomes unpleasant to the eye and also requires more frequent chimney cleaning to prevent possible fires in the chimney.

  • Page 21: Air Control

    7.3 Air control Combustion air control The combustion air regulator is shown in Figure . It controls the amount of air entering the stove, thus controlling the burning of the fuel. On the side of the stove there is 1 regulator that regulates the primary and secondary air at the same time. The primary air must be open during starting, until the wood is properly started, i.e., all the regulator is in the (+) position.

  • Page 22: Using The Unit For The First Time

    8. Using the Unit for the First Time * Ask the installation technician to turn on and start-up the unit to check its proper operation; * The first time the unit is used, the paint finish is cured by the heat, which may generate additional fumes. If this happens, ventilate the room by opening windows and any doors leading to the exterior;...

  • Page 23: Safety

    * In case of fire in the chimney, immediately close the door of the unit, as well as the primary and secondary air inlets; * We recommend that you use only spare parts supplied by the manufacturer – FOGO MONTANHA.

  • Page 24: Cleaning And Maintenance

    11. Cleaning and Maintenance 11.1 Cleaning - Ash build up should be regularly removed from the chamber (but only after turning off the unit and allowing it to cool down); - The glass should always be cleaned with an appropriate product , following the instructions for use and avoiding any contact of the cleaning product with the window rope gasket OR any painted metal parts, –...

  • Page 25: Troubleshooting

    Figure 26 – Sequence that must be followed to remove vermiculite 12. Troubleshooting The apparent malfunction is often caused by misuse. If you think something is wrong with your Stove, see the points below. If the incident is not cleared up after checking these points, you should contact your area representative for assistance.

  • Page 26: Warranty

    A term of 6 months from the date of delivery of the goods, in the case of professional, or industrial, or intensive use of the products – Fogo Montanha means by professional, industrial or intensive use of all products installed in industrial spaces, commercial, or whose use exceeds 1500 hours per calendar year;...
  • Page 27 Monday through Friday within the working time and calendar legally established in each region. All requests for assistance must be submitted to the Fogo Montanha Customer support service, by means of a proper form present on the Website www.fogo-montanha.com, or, e-mail: apoio.cliente@fogo-montanha.com. At the time of the technical assistance to the Product, the Buyer must present, as proof of the Product Warranty, the purchase invoice of the same or another document demonstrating its acquisition.
  • Page 28 Buyer, and the Buyer shall be responsible for any charges arising therefrom. 3.17 The Warranty is valid for the Products and equipment sold by Fogo Montanha solely and exclusively within the geographical and territorial zone of the country where the Product was sold by Fogo Montanha.
  • Page 29 Product, or from abnormal climatic factors, unusual operating conditions, overload or maintenance or cleaning performed improperly; 4.10. The Products that have been modified or manipulated by people outside the Official Technical Services of the brand and consequently without the explicit authorization of Fogo Montanha;...
  • Page 30 4.16. The installation of the equipment supplied by Fogo Montanha should contemplate the possibility of their easy removal, as well as points of access to the mechanical, hydraulic and electronic components of the equipment and the installation.
  • Page 31 Fogo Montanha have a 6-month guarantee. Warranty Spare Parts provided by Fogo Montanha The parts supplied by Fogo Montanha, in the scope of the commercial sale of spare parts, that is to say, not incorporated in the equipment do not have a guarantee.

  • Page 32: Statement Of Performance

    14. Statement of Performance ECLARAÇÃO DE ESEMPENHO ECLARACIÓN RESTACIONES ECLARATION OF ERFORMANCE ÉCLARATION DE ERFORMANCE ICHIARAZIONE DELLE PRESTAZIONI DD-042 º Código de identificação único do produto-tipo | Código de identificación único del tipo de producto | Unique identification code of the product type | Le code d'identification unique du type de produit | Codice unico di identificazione del tipo di prodotto SR 500 P.
  • Page 33 Relatório de ensaio | Informe de la prueba | Test report | Rapport d’essai | Rapporto di prova CEE/0178/17-1 Desempenho declarado | Desempeño declarado | Declared performance | Performance déclarée | Dichiarazione di prestazione Especificações técnicas harmonizadas | Características essenciais | Especificaciones técnicas armonizadas | Características esenciales | Essencial Desempenho | Desempeño |...
  • Page 34 presente declaración se expide bajo la exclusiva responsabilidade del fabricante identificado en lo punto 4. | Performance of the product stated in points 1 and 2 is consistent with the declared performance in point 9. This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4. | Les performances du produit indiqué...
  • Page 35 Please read this Instruction Manual carefully and keep it for future reference. All Fogo Montanha products come with a 2-year warranty. APPROVED PRODUCT...

Table of Contents