Advertisement
Quick Links
WP
- 40
& WP
These wave makers are intended to simulate the natural waves and
whirlpools found in a marine environment.
Before installing and using the pump, please read through these
instructions to familiarise yourself with the correct operation of the device.
- 25 Wave Maker
Features:
• Maximum flow rate of up to 13,000 litres/hour WP-40 (8,000
litres/hour WP-25).
• Unique multi mode controller to allow adjustment of the
wavemaker to suit the users requirements.
• Use of low-voltage, low power, DC variable-speed pump,
minimizing heat transfer to the aquarium and maximising user
safety.
• Easy to use controller
• Adjustable pump housing so pump flow direction can be easily
altered
• Wide voltage input (AC100 ~ 240V 50/60Hz)
• Can be used in a variety of aquarium sizes. Suitable for aquariums
with glass up to 15mm thickness.
Package Contents:
•
Wave maker pump
•
Intelligent controller
•
AC/DC adapter
•
Mains power cord
•
Light sensor (very small) and double sided tape for mounting
controller.
IMPORTANT INFORMATION:
•
In order to ensure product performance, please only operate the
pump in water.
•
The controller is NOT waterproof – please position the controller to
avoid water splashes.
•
Please take care whilst fitting the magnets to the glass.
•
If the Controller or AC/DC adapter are opened, the warranty will be
voided.
•
The Wave maker is suitable for indoor use in water only. The motor
in the wave maker will be damaged if it is run dry.
Advertisement
Related Manuals for Jebao WP-40
Summary of Contents for Jebao WP-40
- Page 1 Features: • Maximum flow rate of up to 13,000 litres/hour WP-40 (8,000 litres/hour WP-25). • Unique multi mode controller to allow adjustment of the wavemaker to suit the users requirements. • Use of low-voltage, low power, DC variable-speed pump, minimizing heat transfer to the aquarium and maximising user safety.
- Page 2 Installation Instructions: Waterproof Pump Every user’s tank is unique, so the wavemaker should be installed based on Connector your tank’s style and your requirements. Ideally, the wavemaker should be placed opposite a flat glass surface (without a overflow or any irregular glass) in order to gain the greatest effect of reflecting waves.
- Page 3 • W1: Adjustable pulses and speed. Pressing the speed button will cycle from S1 = 100% of max flow rate, S2 = 75% flow of max flow rate, and S3 = 50% of max flow rate. Adjust the controller wave duration knob to change the duration (left decrease, right increase) of the pulses and vary the size of the wave according to your tank.
- Page 4 - see images below: WP-40 =130mm WP-40 = 100mm WP-25 = TBC WP-25 = TBC Jebao Co., Ltd.